article·2013-01-01

Axial balance on cross wedge rolling of asymmetric shaft parts based on response surface methodology

Shu Xuedao

Abstract

When asymmetric shaft parts were fabricated by cross wedge rolling(CWR),the imbalanced axial force will result in axial movement which resulted in steps short and skin defects.For decreasing the imbalanced axial force,the present approach is to combine the law of process parameters influencing on rolling force in CWR with trial and error method to assure that the axial force of both ends is equal or approximately equal by numerical simulation.Trial and error method was not only enormous computation,cumbersome and not intuitive,but also difficult to popularize because it based on each part.The paper used central composite experimental design combined with response surface methodology to obtain the axial force response surface and contour lines,then utilizing the surface and the lines to assist the selection of process parameters so as to guarantee the balance of axial force in CWR asymmetric shaft parts.The method was simple,intuitive,and saved large numbers of time and effort in selecting process parameters and shortened the die design period of asymmetric shaft parts by CWR.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Metallurgy and Material Forming · Metal Forming Simulation Techniques · Metal Alloys Wear and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.