article·2015-01-01

The numerical simulation of Cu/Al contact wire forming during continuous extrusion cladding process

Zhao Hongji

Abstract

Aiming at the problems that the Cu / Al contact wire forming was unsuccessful and the contact of Cu / Al was loose,the continuous extrusion cladding forming process of layered Cu / Al wire was simulated by DEFORM3 D. The quality of Cu / Al contact wire under different die core end diversion angle,length of clad forming zone,billet and the die surface state and extrusion wheel speed were systematically investigated. The results show that,when the die core end diversion angle was 45° ~ 30°,the length of clad forming zone was5 mm,the friction between Al and Cu was increased and the friction between die and Cu was decreased,and the extrusion wheel speed was appropriately raised,all these would be beneficial to the improvement of the compactness of Cu / Al. Based on these results,the Cu / Al contact wire has been tested in TLJ340 machine,the test results verified the simulation ones,and the quality qualified Cu / Al contact wire products have been made.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Metallurgy and Material Forming · Aluminum Alloys Composites Properties · Metallurgy and Material Science

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.