Comments on stereological parameters in paper ‘Microalloyed V–Nb–Ti and V steels: Part 1
Source abstract
Abstract
As an enthusiastic promoter of quantitative characterisation of microstructural geometry by stereological parameters, I appreciate the use of classical stereology in the recent paper by Tanniru et al., as well as the useful conclusions drawn from the data. However, the numbers presented in Table 3 (reproduced below) do not seem consistent and should be checked and/or clarified. By point counting and line scanning, four independent measurements can be made on the particular microstructure: [PP]a, the number fraction of hits on the ferrite (a) on a point grid, and [PL]aa, [PL]PP and [PL]aP, the number of intersection points per unit length of a scanning line and the grain boundaries in the ferrite (aa), the cell boundaries in the pearlite (PP) and the interface boundaries between ferrite and pearlite (aP). From these, a series of useful parameters can be derived. In Table 3, three parameters are shown for both the ferrite and the pearlite, the volume fractions [VV]a and [VV]P, the linear intercept lengths La and LP, and the contiguity ratios Ca and CP, i.e. six parameters of which only four can be independent. Two relationships exist for these parameters one of which is obvious
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Microstructure and Mechanical Properties of Steels · Corrosion Behavior and Inhibition · Machine Learning in Materials Science
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (6)
Show source-provided references
1. 10.1179/174328405X1863810.1179/174328405X18638 ↗
2. DeHoff R. T., and Rhines F. N. (eds.): ‘Quantitative microscopy’: 1968, New York, McGraw-Hill.
3. 10.1179/mst.1993.9.12.109410.1179/mst.1993.9.12.1094 ↗
4. 10.1179/02670830010150874810.1179/026708300101508748 ↗
5. 10.1088/0965-0393/13/2/00410.1088/0965-0393/13/2/004 ↗
6. Exner H. E. · Arch. Eisenhiittenwes · 1966 · 37 · 417