journal article·1997-04-01

Wear resistant surfaces on high temperature titanium alloy and titanium aluminide by diffusion bonding

A. Wisbey, C. M. Ward-Close

Materials Science and Technology· Volume 13· Issue 4
Publisher page

Abstract

Titanium alloys have poor tribological performance and there is considerable interest in producing wear resistant surfaces on titanium. An Fe-Ni alloy (IN 907) and a nickel alloy (HS 242) have been diffusion bonded to the high temperature titanium alloy IMI 829 and to the titanium aluminide (Ti3Al) alloy, Super Alpha-2. A combination of tantalum and nickel interlayers has been used to aid bonding. Using these interlayers, increased joint shear strengths were measured and the plastic deformation to failure was increased. Thermal cycling trials have been performed to assess the elevated temperature performance of some of the joints. A reduction in shear strength after thermal cycling was found for joints with tantalum and nickel interlayers and this was associated with the oxidation of tantalum. Oxidation protection for the tantalum and nickel interlayers would be required for titanium alloys to be used in service above ∼ 450°C.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Aluminum Alloys Composites Properties · Advanced materials and composites · Titanium Alloys Microstructure and Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (8)

Show source-provided references
1. 1969 · 4 · 29
2. 10.1016/0043-1648(91)90249-T10.1016/0043-1648(91)90249-T ↗
3. 10.1007/BF0113237910.1007/BF01132379 ↗
4. 10.1179/02670830222500367710.1179/026708302225003677 ↗
5. 1962 · 5 · 9
6. 10.1016/0167-577X(94)90121-X10.1016/0167-577X(94)90121-X ↗
7. 10.1016/0167-577X(94)90122-810.1016/0167-577X(94)90122-8 ↗
8. 10.1007/BF0240386210.1007/BF02403862 ↗