journal article·1990-02-01

Chin Liu strain rate sensitivity index–strain equation of superplasticity and influence of specimen geometry

Chin Liu, Yi Shi-Gong

Publisher page

Abstract

The influence of specimen geometry on the strain rate sensitivity index–strain (m–δ) relationship has been determined for a Zn–5Al (wt-%) eutectic alloy at a strain rate ɛ of 0·025 min−1 and a temperature of 250°C. It was found that all the m–δ curves were of the type mL=mmax>m0 and > mF for δ0 < δL < δF, where mL is the strain rate sensitivity corresponding to the ‘limit strain’ δL; δ0 (=0) is the initial strain; and δF is the total elongation at fracture. Tests were performed for five values of specimen width/length w0/l0 between 0·15 and 0·39. With increase in w0/l0, it was observed that the m–σ curves shifted to higher positions; the values of total elongation at fracture δF and strain rate sensitivity index at zero strain (δ0) m0 and at the limit strain (δL) mL increased; and the strain rate sensitivity index at fracture strain (δF) mF varied little. Consistent with these findings, increasing the thickness of the specimen from 1 to 2 mm at constant w0/l0 caused a shift in the m–σ curve to the right and increased the value of δF and also the limit strain at maximum value of m. From the m–δ data obtained, a modification to the Chin Liu equation is proposed to take into account specimen geometry δF=(C3,F(m0′− mL′)/(w0/l0)ɛmF−1[ (m0′(w0/l0)]−1)100%, where C is the slope of the m-δ curve; (m0′(w0/l0)=m0, m0′>m0 and (mL′(w0/l0)=mL, mL′>m0 for w0/l0 between 0·15 and 0·39. When w0/l0=1(or w0=l0), the notch effect is eliminated and the total elongation at fracture will take its maximum value.MST/1034
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Microstructure and mechanical properties · Aluminum Alloys Composites Properties · Aluminum Alloy Microstructure Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (3)

Show source-provided references
1. 1985 · 2 · 355
2. 1988 · 5 · 1
3. 1986 · 17 · 24