Microstructures and mechanical properties of milled and continuously cast lead sheet Part 1 Microstructures
Source abstract
Abstract
Milled lead sheet exhibits a recrystallised microstructure, the grain size of which decreases with increasing copper content; copper is present as particles of ~1–5μm in length, formed from the initial needles or plates of the cast billet by spheroidisation, or by particle break-up during rolling. A comparison of materials produced by several manufacturers indicates that the copper distribution and final grain size are dependent on the thermomechanical history of the sheet. Direct method sheet exhibits a cast cellular structure within grains which usually extend through the full thickness of the cast sheet; copper is present as a fine dispersion (particles ~0·5 μm dia.) at cell boundaries. The copper distribution in both materials was stable with prolonged heating (100 h at 200°C), but some grain growth occurred in the milled sheet. It was not possible to obtain a fully dispersed eutectic microstructure at the eutectic composition; primary lead dendrites (or cells) were always present. This is thought to be a result of the difficulty of nucleating a copper particle in the very low copper concentration alloys used in this work.MST/1065
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Material Properties and Applications · Aluminum Alloy Microstructure Properties · Metallurgy and Material Science
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (4)
Show source-provided references
1. 10.1063/1.170882010.1063/1.1708820 ↗
2. 10.1016/0026-0800(72)90018-310.1016/0026-0800(72)90018-3 ↗
3. 1966 · 74 · 239
4. 10.1016/0026-0800(79)90036-310.1016/0026-0800(79)90036-3 ↗