Extrusion of AI–Zn–Mg–Cu–Zr alloys
Source abstract
Abstract
AbstractFour aluminium alloys of different zinc/magnesium ratio have been studied under various extrusion conditions. The alloys were cast in steel book moulds and subjected to initial thermomechanical treatments. Studies were made of hot extrusions and cold hydrostatic extrusions and in each case the changes in the extrusion parameters were analysed. An attempt has been made to explain some of the extrusion defects which appeared in various extruded sections. The extrusion speed was found to be crucial, since sections developed surface cracks at higher speeds. The extrusion speed was also found to vary inversely with the extrusion ratio, with higher speeds at low ratios. A well defined solute–depleted weld zone was observed on each of the four faces of a square tube extruded using a porthole die. Thermal treatment was not found to improve this weak weld zone. Tubes extruded using a floating-mandrel die withstood pressure testing up to 550 MPa.MST/43
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Aluminum Alloy Microstructure Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (4)
Show source-provided references
1. STALEY J. T. · Mater. Eng. · 1976 · 8 · 16
2. 10.1016/0025-5416(74)90120-710.1016/0025-5416(74)90120-7 ↗
3. BALASUBRAMANIAN P. K. · Trans. Indian Inst. Met. · 1978 · 31 · 417
4. AKERET R. · J. Inst. Met. · 1972 · 100 · 202