journal article·1995-07

Effect of SiO 2 content in AI 2 O 3 on interfacial bonding strength of aiuminium/AI 2 ) 3 composite

K.B. Kim, E.P. Yoon

Materials Science and Technology· Volume 11· Issue 7
Publisher page

Abstract

In this study, the interfacial bonding strength between pure aluminium or an aluminium alloy (Al-12Si-1Cu-1Mg-2Ni) and Al 2 O 3 containing 0-20 wt-%SiO 2 was measured using a B scale Rockwell hardness indenter. The interface was analysed using scanning electron microscopy, Auger electron spectroscopy, and X-ray diffraction. The results obtained were as follows. In the pure aluminium/Al 2 O 3 composite the interfacial bonding strength was not strongly affected by the SiO 2 additions, but the interfacial strength of the aluminium alloy/Al 2 O 3 composite could be significantly improved by small additions (2-5 wt-%) of SiO 2 in the Al 2 O 3 . Magnesium was the only alloying element to segregate at the interface. At the interface of the pure aluminium/Al 2 O 3 –20SiO 2 specimen, Al 2 O 3 and silicon were detected, and MgAl 2 O 4 and Al 2 O 3 were detected in the aluminium alloy/Al 2 O 3 –20SiO 2 specimen. The interfacial chemical reaction involving magnesium is believed to be important in increasing the interfacial bonding strength.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Aluminum Alloys Composites Properties · Advanced ceramic materials synthesis · Advanced Surface Polishing Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Metallurgical Engineering, Hanyang University, Seoul, Korea

Division of Metals, Korea Institute of Science and Technology, Cheongryang, Seoul, Korea

References (11)

Show source-provided references
1. J. W. LUSTER M. THUMANN and R. BAUMANN: Mater. Sci. Technol. 1993 9 (10) 853–862.10.1179/mst.1993.9.10.853 ↗
2. I. A. IBRAHIM F. A. MOHAMED and E. J. LAVERNIA: J. Mater. Sci. 1991 26 1137.10.1007/BF00544448 ↗
3. T. W. CHOU A. KELLY and A. OKURA: Composites 1985 16 187.10.1016/0010-4361(85)90603-2 ↗
4. M. P. THOMAS and J. E. KING: Mater. Sci. Technol. 1993 9 (9) 742–753.
5. S. BENGTSSON and R. WARREN: Mater. Sci. Technol. 1993 9 (4) 319–327.10.1179/026708393790172042 ↗
6. F. DELANNAY L. FROYEN and A. DERUYTTER: J. Mater. Sci. 1987 22 1.10.1007/BF01160545 ↗
7. A. WATANABE H. KATO and K. YOSHIKAWA: Mater. Sci. Technol. 1993 9 (2) 155–160.10.1179/026708393790171782 ↗
8. D. L. McDANELS: Metall. Trans. 1985 16A 1105.10.1007/BF02811679 ↗
9. J. E. SCHOUTENS and K. TEMPO: in ‘Introduction to metal matrix composite materials’ 4-56; 1982 California DoD Metal Matrix Composites Information Analysis Center.
10. D. B. MARSHALL: J. Am. Ceram. Soc. 1984 67 C–259.10.3168/jds.S0022-0302(84)81556-8 ↗
11. A. MORTENSEN and I. JIN: Int. Mater. Rev. 1992 37 (3) 101–128.10.1179/imr.1992.37.1.101 ↗