journal article·1994-12-01

Isothermal transformation diagrams for alloyed ductile cast iron

M. Bahmani, R. Elliott

Materials Science and Technology· Volume 10· Issue 12
Publisher page

Abstract

Isothermal transformation (IT) diagrams which were determined metallographically are presented for a ductile cast iron alloyed with manganese, molybdenum, and copper, following austenitisation at 870 and 920°C. Isothermal transformations were conducted over the temperature range 275–650°C for times between 0·5 and 120 min. The IT diagrams displayed a nose at ~650 and 425°C for the pearlite and upper bainite reactions respectively. The diagrams could be separated into two overlapping diagrams corresponding to transformations in the eutectic cell and intercellular regions. When compared with previous data for an unalloyed iron, the alloying additions were found to delay the transformation, and to a greater extent above 450°C than below this temperature. Increasing the austenitising temperature was observed to delay the transformation. The effect of a 50 K increase was equivalent to increasing the total alloy content in the eutectic cell area by about 0·4 wt-% in this alloy.MST/2040
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Microstructure and Mechanical Properties of Steels · Metal Alloys Wear and Properties · Metallic Glasses and Amorphous Alloys

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (4)

Show source-provided references
1. 1990 · 98 · 519
2. 1993 · 9 · 586
3. 1990 · 98 · 449
4. 10.1179/02670830112500018610.1179/026708301125000186 ↗