journal article·1994-08

Liquidus projection of Ti–Al–Si ternary systemin vicinity of γ alloys

S. H. Manesh, H. M. Flower

Materials Science and Technology· Volume 10· Issue 8
Publisher page

Abstract

The microstructure, nature, distribution, and chemical composition of the different phases obtained in γ-TiAl alloys with small amounts of silicon additions have been investigated. Based on the microstructures observed and results obtained via energy dispersive X -ray microanalysis, the approximate partial liquidus projection of the ternary Ti–Al–Si system in the range of compositions over which γ alloys exist, has been established. Two four phase invariant points on which peritectic reactions occur are present. The eutectic valley between β and Ti 5 (Si, Al) 3 phases exhibits a maximum point, and the liquidus surface in this region is of saddle type. The results were found to be in good agreement with predictions based on thermodynamic modelling. MST/1937
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Metallurgical and Alloy Processes · Intermetallics and Advanced Alloy Properties · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (15)

Show source-provided references
1. ANTONY K. C.: Trans. AIME, 1968, 242, 1454.
2. PATON N. E., and AHONEY M. W.: Metall. Trans., 1975, 74, 1685.
3. Es-SOUNI M. BEAVEN P. A. WAGNER R. CHEN D. BARTELS A. and SEEGER F.: in Proc. 2nd European Conf. on Advanced Materials and Processes ‘Euromat ‘91’ 226–229; 1992 London The Institute of Materials.
4. KASAHARA K. HASHIMOTO K. DOI H. and TSUJIMOTO T.: ‘Collected abstracts of the 1987 autumn meeting of the Japan Institute of Metals’ Sendai Japan 313 September1987.
5. MURRAY J. L.: ‘Phase diagrams of binary titanium alloys’ (ed. Murray J. L. ); 1987 Metals Park OH ASM.
6. PAJUNEN M. KIVILAHTI J. and MIETTINEU J.: in Proc. 1st European Conf. on ‘Advanced materials and processes’ (Euromat 89) (ed. Exner H. E. and Schumacher V. Vol. 2 1055–1060; 1989 Informationsgesellschaft Verlag.
7. ZHANG ZHU and FLOWER N. M. Mater. Sci. Technol. 1991 7 812–817.10.1179/026708391790184960 ↗
8. Es-SOUNI M., , BEAVEN P. A., and. WAGNER: SCY. Metall., 1990, 24, 2175–2180.
9. KIM Y. W.: in MRS Symp. Proc. on ‘High temperature ordered intermetallic alloys IV’ (ed. Johnson L. et al.) Vol. 213 777–794; 1991 Pittsburgh PA Materials Research Society.
10. 10.1016/0956-716X(90)90593-610.1016/0956-716X(90)90593-6 ↗
11. ‘ThermoCalc version J’ Division of Physical Metallurgy Royal Institute of Technology Stockholm Sweden 1992.
12. HINSDALE A.: SGTE data for pure elements NPL report DMA(A)195 rev. August 1990.
13. SAUNDERS N.: ‘Ti—Al—V systems’ Report COST 507 Royal Institute of Technology Stockholm 1991.
14. PAJUNEN M.: unpublished work Helsinki University of Technology 1989.
15. LUDECKE D.: Z. Metallkde, 1986, 77, 278–283.