Influence of welding conditions and residual stresses on strength of Al2O3/Ti diffusion welds
Source abstract
Abstract
AbstractDiffusion welding of titanium cylinders to an alumina cylinder (Ti/Al2O3/Ti) was carried out at temperatures above the α–β transition temperature of titanium. Titanium and alumina were welded under the following conditions: maximum heating temperature greater than 1400 K, holding time of 30 s, heating (cooling) rate of 1–10 K s−1, welding pressure of 1·6 MPa, and an air atmosphere. The shear strength of Ti/Al2O3/Ti welds was very low because of the residual stress at the welded interface. Alumina cylinders were welded using titanium foil as an insert (AI2O3/Ti foil/Al2O3). The shear strength of Al2O3/Ti foil/Al2O3 welds increased slightly with the decrease of foil thickness, and attained a maximum value of 82 MN m−2. When the foil thickness was less than 10 μm, the welds failed at the welded interface, but the welds with foil of 100 μm thickness failed in alumina close to the interface.MST/1114
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced Welding Techniques Analysis · Metal and Thin Film Mechanics · MXene and MAX Phase Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (11)
Show source-provided references
1. KING W. R. · Weld. J. · 1967 · 46 · 289s
2. 10.1179/mst.1988.4.8.66910.1179/mst.1988.4.8.669 ↗
3. 10.1179/mst.1986.2.4.40510.1179/mst.1986.2.4.405 ↗
4. 10.1007/BF0055043810.1007/BF00550438 ↗
5. 10.1179/mst.1985.1.9.65710.1179/mst.1985.1.9.657 ↗
6. SUGANUMA K. · J. Therm. Spray. Soc. Jpn · 1985 · 22 · 929
7. SHIMPO A. · Jpn · 1987 · 36 · 1212
8. 10.1007/BF0055066210.1007/BF00550662 ↗
9. 10.2207/qjjws1943.46.99710.2207/qjjws1943.46.997 ↗
10. 10.1016/0001-6160(63)90115-910.1016/0001-6160(63)90115-9 ↗
11. 10.1016/0001-6160(64)90075-610.1016/0001-6160(64)90075-6 ↗