journal article·1990-04

Laser cutting of glass ceramic matrix composite

J. A. Ridealgh, R. D. Rawlings, D. R. F. West

Publisher page

Abstract

The laser cutting of a glass ceramic matrix composite containing about 50 vol.-% aligned SiC fibres has been investigated. A 2 kW CW (continuous wave) CO2 laser equipped with an x–y table was used with varying beam diameter, power, and table speed to give a range of processing conditions. The dimensions (depth and width) of the cuts were measured as a function of the processing conditions and the cut surfaces were examined using scanning electron microscopy and X-ray diffraction. Full through-section cuts, having vertical sides? were obtained using a narrow 1mm diameter beam operating at a (power density) / (table velocity) ratio in excess of approximately 30 J mm−3. The surface condition after laser cutting was superior to that obtained using conventional diamond sawing.MST/1168
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advanced Surface Polishing Techniques · Laser Material Processing Techniques · Advanced ceramic materials synthesis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (4)

Show source-provided references
1. HARRY J. E. · IEEE Trans. Ind. Appl. · 1972 · IA–8, 418
2. LUMLEY R. M. · Ceram. Bull. · 1969 · 48 · 850
3. ann G. K. · Ceram. Bull. · 1975 · 54 · 514
4. KIM H. S. · Br. Ceram. Trans. J. · 1989 · 88 · 21