journal article·2013-08

Solid state diffusion bonding of Ti–6Al–4V and Co–28Cr–5Mo–0·3C alloys

R Bahrami, H Omidvar, Sh Zangeneh, M Ketabchi

Materials Science and Technology· Volume 29· Issue 8
Publisher page

Abstract

An attempt to investigate solid state diffusion bonding of Ti–6Al–4V and Co–28Cr–5Mo–0·3C alloys has been made. The results showed that the joint could not be successfully bonded at 800°C, even though longer period of holding times (>1 h) was used. However, at 850°C, successful joining was achieved at holding time of 1 h. It was found that increasing temperature up to 900°C gave rise to intermetallic component formation, mainly Co3Ti, at the joining interface, which contributed to weak bonding strength. This technique provides a reliable method of bonding of Ti–6Al–4V to Co–28Cr–5Mo–0·3C alloys, which is very helpful in the development of biomaterial industry.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Titanium Alloys Microstructure and Properties · Advanced Welding Techniques Analysis · Intermetallics and Advanced Alloy Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Mining and Metallurgical Engineering Department Amirkabir University of Technology, Tehran, Iran

References (9)

Show source-provided references
1. 10.1007/s11661-006-0232-610.1007/s11661-006-0232-6 ↗
2. 10.1016/j.matdes.2011.12.04110.1016/j.matdes.2011.12.041 ↗
3. 10.1016/j.msea.2010.06.08110.1016/j.msea.2010.06.081 ↗
4. 10.1016/j.msea.2010.03.01810.1016/j.msea.2010.03.018 ↗
5. Niinomi M · Mater. Sci. Eng. A · 2000 · 243 · 23110.1016/S0921-5093(97)00806-X ↗
6. Li ZC · Rare Met. Mater. Eng. · 1998 · 27 · 59
7. Kemal A · Mater. Des. · 2012 · 356
8. 10.1016/j.matdes.2010.02.02110.1016/j.matdes.2010.02.021 ↗
9. 10.1016/j.jallcom.2010.03.07010.1016/j.jallcom.2010.03.070 ↗