journal article·2022-11

Layer-by-layer analysis: Tribological behaviour of Ni60A coating on copper substrate prepared by plasma cladding

Chao Zhang, Ruidong Wang, Rong Hu, Yuwen Zhang, Wenhe Wu, Xionggang Lu

Materials Science and Technology· Volume 38· Issue 17
Publisher page

Abstract

To further clarify the characteristics of plasma-cladded Ni60A coating on copper, the microstructure and wear behavior were analyzed layer by layer. Along the depth direction, the coating can be divided into three regions according to the difference of microstructure: upper, middle and bottom. The phase composition in different regions was the same (including γ-(Cu, Fe, Ni), Cr 23 C 6 , CrB and Ni 3 Si), and there was no obvious difference in the volume fraction of strengthening phases (Cr 23 C 6 and CrB). Due to the stronger load-bearing capacity of larger-size strengthening phases, the wear resistance of middle region was slightly higher than that of upper region. However, the high copper content in bottom region led to a decrease in hardness and resistance to plastic shear, which significantly reduced the wear resistance (2.3 times lower than upper region). Chemical composition had a greater impact on the wear resistance than size and distribution uniformity of strengthening phases.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Diamond and Carbon-based Materials Research · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

State Key Laboratory of Advanced Special Steel & Shanghai Key Laboratory of Advanced Ferrometallurgy & School of Materials Science and Engineering, Shanghai University, Shanghai, People's Republic of China

Funding

Steel Joint Research Foundation of National Natural Science Foundation of China–China Baowu Iron and Steel Group Co. Ltd · National Natural Science Foundation of China · Independent Research and Development Project of State Key Laboratory of Advanced Special Steel · Shanghai Key Laboratory of Advanced Ferrometallurgy · Shanghai University · Science and Technology Commission of Shanghai Municipality

References (27)

Show source-provided references
1. 10.1016/j.vacuum.2020.10958110.1016/j.vacuum.2020.109581 ↗
2. 10.1515/htmp-2014-014910.1515/htmp-2014-0149 ↗
3. 10.1016/j.apsusc.2007.01.08610.1016/j.apsusc.2007.01.086 ↗
4. Zhang C · Surf Technol · 2021 · 50 · 135
5. 10.1016/j.jallcom.2010.06.09910.1016/j.jallcom.2010.06.099 ↗
6. 10.1016/j.jmrt.2021.08.11410.1016/j.jmrt.2021.08.114 ↗
7. 10.1016/j.surfcoat.2010.05.02210.1016/j.surfcoat.2010.05.022 ↗
8. 10.1016/j.wear.2011.01.00310.1016/j.wear.2011.01.003 ↗
9. 10.1016/j.triboint.2019.10600210.1016/j.triboint.2019.106002 ↗
10. 10.1016/S0301-679X(02)00144-510.1016/S0301-679X(02)00144-5 ↗
11. 10.1016/j.triboint.2012.08.01310.1016/j.triboint.2012.08.013 ↗
12. 10.1016/j.wear.2011.01.02510.1016/j.wear.2011.01.025 ↗
13. 10.1016/j.triboint.2018.06.02210.1016/j.triboint.2018.06.022 ↗
14. 10.1016/j.surfcoat.2015.09.03410.1016/j.surfcoat.2015.09.034 ↗
15. 10.1016/j.optlastec.2015.03.01510.1016/j.optlastec.2015.03.015 ↗
16. 10.1016/j.wear.2016.01.01510.1016/j.wear.2016.01.015 ↗
17. 10.1080/09507116.2016.121860810.1080/09507116.2016.1218608 ↗
18. 10.3390/coatings1109108010.3390/coatings11091080 ↗
19. 10.1016/j.matlet.2021.13088310.1016/j.matlet.2021.130883 ↗
20. 10.1016/j.apsusc.2011.10.00610.1016/j.apsusc.2011.10.006 ↗
21. 10.1007/s11661-013-2004-410.1007/s11661-013-2004-4 ↗
22. 10.1016/j.matlet.2012.06.05410.1016/j.matlet.2012.06.054 ↗
23. 10.1007/s11665-012-0271-710.1007/s11665-012-0271-7 ↗
24. 10.1016/j.optlastec.2011.12.03110.1016/j.optlastec.2011.12.031 ↗
25. 10.1016/S0043-1648(99)00183-010.1016/S0043-1648(99)00183-0 ↗
26. 10.1016/j.wear.2019.04.00510.1016/j.wear.2019.04.005 ↗
27. 10.1016/j.ceramint.2020.08.07110.1016/j.ceramint.2020.08.071 ↗