journal article·2013-01

Effect of incorporation of zirconia layer upon physical and mechanical properties of investment casting ceramic shell

C Yuan, P A Withey, S Blackburn

Materials Science and Technology· Volume 29· Issue 1
Publisher page

Abstract

Post-heat treatment recrystallisation is a significant cause of scrap in single crystal component production. This defect could be prevented by a reduction in the mechanical strength of the shell after the metal has solidified. Addition of a zirconia layer, to produce large cracks around grain boundaries and among the large grains during phase transformations, was considered as a method of reducing sintered strength. In this study, two types of zirconia stucco, monoclinic and partially stabilised, were introduced into the shell. The effect of the incorporation of a zirconia layer on the microstructure and mechanical properties of the shell were investigated. Shell with a monoclinic zirconia additional layer showed no reduction in the green strength but a better performance in high temperature deformation tolerance, maintaining shell performance during wax removal and metal casting. The shell strength after alloy solidification is reduced, suggesting that a reduction in recrystallisation may be possible with this method.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Advanced ceramic materials synthesis · Materials Engineering and Processing · Aluminum Alloys Composites Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

School of Metallurgy and Materials, The University of Birmingham, Birmingham B15 2TT, UK

Rolls-Royce plc., Derby DE 24 8BJ, UK

References (16)

Show source-provided references
1. Jones S · Br. Ceram. Trans. · 1995 · 94 · 68
2. Beeley PR, Smart RF: ‘Investment casting’, 1st edn; 1995, London, Institute of Materials.
3. Meulenberg WA · CFI-Ceram. Forum Int. · 2000 · 77 · 30
4. 10.1115/1.281660010.1115/1.2816600 ↗
5. Caron P · La Rech. Aerosp. · 1996 · 5 · 353
6. 10.1179/mst.1986.2.5.42610.1179/mst.1986.2.5.426 ↗
7. 10.1115/1.281818810.1115/1.2818188 ↗
8. Hyde R, Withey P, Leyland S: ‘Hot distortion mechanisms of moulds for investment casting’, Proc. 9th World Conf. on ‘Investment casting’, October 1996, San Francisco, CA, USA, Investment Casting Institute, Paper 4.
9. 10.1002/pssa.221021010210.1002/pssa.2210210102 ↗
10. 10.1016/j.dental.2007.05.00510.1016/j.dental.2007.05.005 ↗
11. Garvie RC · J. Aust. Ceram. Soc. · 1977 · 13 · 8
12. Pascoe RT · Sci. Ceram. · 1977 · 9 · 447
13. 10.1016/0390-5519(80)90028-910.1016/0390-5519(80)90028-9 ↗
14. 10.1107/S002188986900721710.1107/S0021889869007217 ↗
15. 10.1016/j.matdes.2005.12.00410.1016/j.matdes.2005.12.004 ↗
16. Connolly S · Foundry Trade J. · 1998 · 172 · 436