Compression deformation behaviours of ultrafine and coarse grained commercially pure titanium
Source abstract
Abstract
Hot compression deformation behaviours of ultrafine grained (UFG) and coarse grained (CG) commercially pure (CP)-Ti were investigated and compared by isothermal simulation tests. Strains over 50 were achieved in these tests over a temperature range of 298–823 K and strain rate of 10−4–10−2 s−1. The results show that the peak stresses of UFG and CG CP-Ti fall with increasing deformation temperature and decreasing strain rate. Within the plastic deformation regime, the compressive stress–strain responses of UFG and CG CP-Ti exhibit quite different features, which strongly depend on the temperature and strain rate. The flow stress of CG CP-Ti monotonically increases with strain, while that of UFG CP-Ti increases first and then tends to be constant after a peak value below recrystallisation temperature. The stress–strain curves of UFG CP-Ti show similar characteristic with those of CG CP-Ti as the temperature is above recrystallisation temperature. Strain rate sensitivity values m of the UFG CP-Ti increase with the rise in temperature and are higher than those of CG CP-Ti. It can be concluded that deformation of UFG CP-Ti is controlled by grain boundary and dislocation activity.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Microstructure and mechanical properties · High-Velocity Impact and Material Behavior · Titanium Alloys Microstructure and Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
School of Metallurgical Engineering, Xi'an University of Architecture and Technology, Xi'an 710055, China
References (32)
Show source-provided references
1. 10.1016/j.cirp.2008.09.00510.1016/j.cirp.2008.09.005 ↗
2. 10.1016/j.msea.2012.08.04010.1016/j.msea.2012.08.040 ↗
3. 10.1016/j.jallcom.2008.06.16110.1016/j.jallcom.2008.06.161 ↗
4. 10.1016/j.msea.2012.03.01210.1016/j.msea.2012.03.012 ↗
5. 10.1016/j.scriptamat.2011.01.03010.1016/j.scriptamat.2011.01.030 ↗
6. 10.1016/S1003-6326(08)60442-210.1016/S1003-6326(08)60442-2 ↗
7. 10.1016/j.actamat.2004.07.00310.1016/j.actamat.2004.07.003 ↗
8. 10.1016/j.actamat.2007.06.03610.1016/j.actamat.2007.06.036 ↗
9. 10.1016/j.scriptamat.2009.03.03210.1016/j.scriptamat.2009.03.032 ↗
10. 10.1016/j.cap.2005.07.05310.1016/j.cap.2005.07.053 ↗
11. 10.1016/j.scriptamat.2004.04.01110.1016/j.scriptamat.2004.04.011 ↗
12. 10.1016/S0921-5093(00)01884-010.1016/S0921-5093(00)01884-0 ↗
13. 10.1016/j.msea.2009.09.00510.1016/j.msea.2009.09.005 ↗
14. 10.1016/j.matdes.2010.01.00410.1016/j.matdes.2010.01.004 ↗
15. 10.1016/j.scriptamat.2008.05.00110.1016/j.scriptamat.2008.05.001 ↗
16. 10.1016/j.msea.2010.06.04910.1016/j.msea.2010.06.049 ↗
17. 10.1016/j.msea.2011.06.05410.1016/j.msea.2011.06.054 ↗
18. 10.1016/j.msea.2011.07.03210.1016/j.msea.2011.07.032 ↗
19. 10.1063/1.138400010.1063/1.1384000 ↗
20. 10.1016/j.scriptamat.2006.01.03410.1016/j.scriptamat.2006.01.034 ↗
21. 10.1016/j.msea.2007.04.06910.1016/j.msea.2007.04.069 ↗
22. 10.2320/matertrans.M201104110.2320/matertrans.M2011041 ↗
23. Blum W · Mater. Sci. Eng. A · 2006 · 462 · 275
24. 10.1016/1359-6462(96)00107-810.1016/1359-6462(96)00107-8 ↗
25. Liu XY · Rare Met. Mater. Eng. · 2012 · 41 · 667
26. 10.1016/S1359-6454(99)00203-710.1016/S1359-6454(99)00203-7 ↗
27. 10.1016/S0921-5093(00)01411-810.1016/S0921-5093(00)01411-8 ↗
28. Li YJ: ‘Deformation behavior of ultrafine-grained copper’, PhD thesis, University of Erlangen–Nürnberg, Erlangen–Nürnberg, Germany, 2006.
29. 10.4028/www.scientific.net/MSF.667-669.70710.4028/www.scientific.net/MSF.667-669.707 ↗
30. 10.1016/j.msea.2004.03.06410.1016/j.msea.2004.03.064 ↗
31. 10.1016/j.actamat.2004.05.04210.1016/j.actamat.2004.05.042 ↗
32. 10.1016/0001-6160(73)90057-610.1016/0001-6160(73)90057-6 ↗