Decomposition modes of austenite in 9Cr–W–V–Ta reduced activation ferritic–martensitic steels
Source abstract
Abstract
The present paper presents the results of an extensive electron microscopy investigation on the decomposition modes of high temperature austenite in 9Cr–W–V–Ta reduced activation ferritic–martensitic steels. Although the displacive martensitic transformation is predominant on austenitisation, low volume fraction of Fe rich M3C or M23C6 precipitates formed, when the tungsten content exceeded 1 wt-. The compositional inhomogeneity introduced in the austenite by the nature, chemistry and kinetics of dissolution of the pre-existing carbides is dependent on the steel composition and austenitisation conditions. The extent of repartitioning of tungsten between M23C6 and ferrite largely influences the kinetics of austenite and martensite transformation, for the same austenitisation conditions. Supporting evidence from calorimetry analysis is also presented.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Microstructure and Mechanical Properties of Steels · High Temperature Alloys and Creep · Metal Alloys Wear and Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
Metallurgy & Materials Group, Indira Gandhi Centre for Atomic Research, Kalpakkam 603102, India
Senior Research Fellow, Homi Bhabha National Institute at IGCAR, Kalpakkam, India
TBM Division, Institute for Plasma Research, Gandhi Nagar, India
References (57)
Show source-provided references
1. 10.1016/0022-3115(94)90145-710.1016/0022-3115(94)90145-7 ↗
2. 10.1016/S0022-3115(86)80091-510.1016/S0022-3115(86)80091-5 ↗
3. 10.1088/0029-5515/44/1/00610.1088/0029-5515/44/1/006 ↗
4. 10.1088/1468-6996/9/1/01300210.1088/1468-6996/9/1/013002 ↗
5. 10.1016/j.jnucmat.2011.05.02310.1016/j.jnucmat.2011.05.023 ↗
6. 10.1016/j.anucene.2009.05.00210.1016/j.anucene.2009.05.002 ↗
7. 10.1520/MONO3-EB10.1520/MONO3-EB ↗
8. Batista MN · Mater. Sci. Technol.
9. Santella ML, Swindeman RW, Reed RW and Tanzosh JM: ‘Martensite formation in 9Cr–1Mo steel weld metal and its effect on creep behaviour’, Proc. EPRI Conf. on ‘9Cr materials fabrication and joining technologies’, Myrtle Beach, CA, USA, July 2001, EPRI, Report 1006299.
10. Beres L · Weld. J. · 2001 · 80 · s191
11. 10.1016/j.fusengdes.2012.01.02010.1016/j.fusengdes.2012.01.020 ↗
12. 10.1179/mst.1992.8.12.106310.1179/mst.1992.8.12.1063 ↗
13. 10.2355/isijinternational.41.61210.2355/isijinternational.41.612 ↗
14. 10.1016/j.jnucmat.2008.05.01010.1016/j.jnucmat.2008.05.010 ↗
15. 10.1016/S0022-3115(02)00885-110.1016/S0022-3115(02)00885-1 ↗
16. 10.1179/1743284710Y.000000003910.1179/1743284710Y.0000000039 ↗
17. 10.1007/s11661-012-1311-510.1007/s11661-012-1311-5 ↗
18. 10.1088/1468-6996/9/1/01300210.1088/1468-6996/9/1/013002 ↗
19. 10.2355/isijinternational.41.64110.2355/isijinternational.41.641 ↗
20. 10.1179/02670830322501068710.1179/026708303225010687 ↗
21. Ennis PJ · OMMI · 2002 · 1 · 1
22. Ghassemi Armaki H · J. Phys. Conf. Ser. · 2010 · 240 · 1
23. 10.1016/j.matchar.2013.08.00310.1016/j.matchar.2013.08.003 ↗
24. Wang PH, Chen JM and Xu ZY: ‘Research and development of reduced activation ferritic/martensitic steel CLF-1 at SWIP’, Proc. 23rd IAEA Fusion Energy Conf., Daejon, Korea, October 2010, IAEA, FTP/P1–24.
25. 10.1016/S0921-5093(01)01874-310.1016/S0921-5093(01)01874-3 ↗
26. 10.1016/S0968-4328(00)00086-X10.1016/S0968-4328(00)00086-X ↗
27. 10.2355/isijinternational.45.10710.2355/isijinternational.45.107 ↗
28. 10.1007/BF0266504810.1007/BF02665048 ↗
29. 10.1007/BF0266109810.1007/BF02661098 ↗
30. 10.2355/isijinternational.34.19810.2355/isijinternational.34.198 ↗
31. 10.1016/j.nucengdes.2011.04.03910.1016/j.nucengdes.2011.04.039 ↗
32. 10.1016/j.jnucmat.2011.01.05410.1016/j.jnucmat.2011.01.054 ↗
33. 10.1016/j.jnucmat.2010.12.24810.1016/j.jnucmat.2010.12.248 ↗
34. Ohms C, Neov D and Youtsos AG: ‘Evaluation of novel post weld heat treatment in ferritic steel repair welds based on neutron diffraction’, ‘Residual stress and its effect on fatigue and fracture’, Proc. 16th European Conf. on ‘Fracture’, Alexandroupolis, Greece, July 2006, Springer, 55–66.10.1007/1-4020-5329-0_5 ↗
35. 10.1016/j.jnucmat.2013.03.07310.1016/j.jnucmat.2013.03.073 ↗
36. 10.13182/FST13-69010.13182/FST13-690 ↗
37. http://rsb.info.nih.gov/ij/
38. 10.1016/j.jnucmat.2009.02.03010.1016/j.jnucmat.2009.02.030 ↗
39. Ravikirana SRaju, Mythili R, Saroja S, Jayakumar T and Rajendra Kumar E: ‘Effect of heating rate on transformation temperature of 9Cr–W TaV reduced activation ferritic/martensitic steels’, Proc. 19th Symp. and Workshop on ‘Thermal analysis’, Mumbai, India, August 2013, ITAS, 414–419.
40. Ravikirana SRaju · Steel Res. Int.
41. 10.1179/026708309X1250693387326010.1179/026708309X12506933873260 ↗
42. JMatpro 4·1. http://www.sentesoftware.co.uk/
43. 10.1016/j.scriptamat.2008.05.03610.1016/j.scriptamat.2008.05.036 ↗
44. 10.1016/j.actamat.2009.07.02510.1016/j.actamat.2009.07.025 ↗
45. Vermeulen WG · Ironmaking Steelmaking · 1996 · 23 · 433
46. 10.1007/BF0265391610.1007/BF02653916 ↗
47. 10.31399/asm.tb.htgpge.978162708347810.31399/asm.tb.htgpge.9781627083478 ↗
48. Buck RHJr and McCullough DG: ‘Alloy steel forging die’, US patent no. 3,131,057, 28 April 1964.
49. 10.1179/174328005X4114010.1179/174328005X41140 ↗
50. Yoshiaki I · J. Phase Equilib. Diffus. · 2005 · 26 · 46610.1007/s11669-005-0036-1 ↗
51. Londolt B: ‘Diffusion in solids, metals and alloys’, 125; 1990, Berlin, Springer-Verlag.
52. 10.1016/0956-7151(95)00022-N10.1016/0956-7151(95)00022-N ↗
53. Saroja S: ‘Study of microstructure, microchemistry and lattice strain in wrought 9Cr–1Mo steel using analytical transmission electron microscopy, convergent beam electron diffraction and thermodynamic computations’, PhD thesis, University of Madras, Chennai, India, 1999.
54. 10.1007/s11661-999-0042-810.1007/s11661-999-0042-8 ↗
55. Ravikirana RMythili · Bulletin Mater. Sci.
56. 10.1080/0141861990821038510.1080/01418619908210385 ↗
57. Dyson DJ and KeownSR: ‘Interpretation of electron diffraction patterns’, 1st edn, 166; 1967, New York, Plenum.