journal article·1990-04

Effect of high cutting speed on surface integrity of AISI 4340 steel during turning

A. B. Sadat

Publisher page

Abstract

AbstractThe effect of high cutting speed and feed rate on the surface integrity of AISI 4340 steel during a finishing turning operation was investigated. The experimental work involved the determination of residual stress distribution in the surface region, microhardness variation of the surface region, and the examination of surface and subsurface using both optical and scanning electron microscopy. The residual stresses were found to be compressive. The microhardness in the surface region varied little and was the same as that of the bulk material. In general, the appearance of the surface was similar to those reported for low cutting speeds as recommended for machining the same type of steel.MST/998
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Advanced machining processes and optimization · Metal and Thin Film Mechanics · Advanced Machining and Optimization Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (22)

Show source-provided references
1. 10.1115/1.343908110.1115/1.3439081 ↗
2. LAU W. S. · Israel J. Technol. · 1971 · 9 · 305
3. THOMSEN E. G. · Series B · 1962 · 84 · 53
4. TURLEY D. M. · J. Inst. Met. · 1968 · 96 · 82
5. B. F. VON TURKOVICH and S. RAMALINGAM: ‘Mechanical state of machined surface’, SME Paper no., IQ 73-603, Society of Manufacturing Engineers, Dearborn, MI, 1973.
6. 10.1115/1.322593810.1115/1.3225938 ↗
7. 10.1115/1.343906310.1115/1.3439063 ↗
8. 10.1007/BF0231886810.1007/BF02318868 ↗
9. 10.1520/JTE11237J10.1520/JTE11237J ↗
10. 10.1115/1.322569110.1115/1.3225691 ↗
11. SADAT A. B. · Int. J. Mach. Tool Des. Res. · 1987 · 27 · 1
12. 10.1115/1.318706010.1115/1.3187060 ↗
13. 10.1016/S0007-8506(07)63344-710.1016/S0007-8506(07)63344-7 ↗
14. FRISCH J. · Trans. ASME · 1951 · 73 · 338
15. LIU C. R. · J. Eng. Ind. (Trans. ASME), 1982, 104, 257-264 (Paper no. 82—prod-8).
16. 10.1115/1.366300410.1115/1.3663004 ↗
17. 10.1299/jsme1958.18.12310.1299/jsme1958.18.123 ↗
18. LETNER H. R. · Trans. ASME · 1955 · 77 · 1089
19. 10.1016/S0007-8506(07)60172-310.1016/S0007-8506(07)60172-3 ↗
20. COLWELL L. V. · Trans. ASME · 1955 · 77 · 1099
21. OKUSHIMA K. · CIRP Ann. Manuf. Technol. 1971, 20, Manufacturing Technology (1), 13-14
22. FIELD M. · Oct · 1964 · pp. 54