Sliding temperature and wear behaviour of cast Al–Si base alloy
Source abstract
Abstract
AbstractAbstractThe influence of sliding interface temperature on friction and wear behaviour of eutectic (LM13) and hypereutectic (LM28) Al–Si base alloy in as cast and heat treated condition has been investigated. LM13 and LM28 alloys having nominal composition Al–12Si–1Ni–0.8Cu–0.6Mg and Al–17Si–1Ni–0.8Cu–0.6Mg used in this study. Wear and friction tests were performed under dry sliding conditions using a pin on disc type of friction and wear monitor with the data acquisition system conforming to ASTM G99 standard. It was found that sliding interface temperature has a close relation with wear and friction response of these alloys. Initial rise in temperature reduces the wear rate and as soon as a critical temperature (CT) is crossed, wear rate abruptly increases. The friction coefficient of both alloys first decreases with rise in temperature then subsequently increases beyond a certain temperature. The influence of temperature on wear behaviour in particular was found to be a function of alloy composition and heat treatment. For as cast LM28 alloy, the critical temperature (140°C) was found to be lower than that in the heat treated condition (180°C). A temperature–wear mechanism is proposed for these alloys.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Microstructure and mechanical properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (4)
Show source-provided references
1. 10.1007/BF0055244810.1007/BF00552448 ↗
2. 10.1016/0025-5408(91)90153-D10.1016/0025-5408(91)90153-D ↗
3. 10.1063/1.165863010.1063/1.1658630 ↗
4. LEVINSON D. W. · Trans ASM · 1956 · 46 · 689