Wire electrical discharge machining of Al 2 O 3 particle and short fibre reinforced aluminium based composites
Source abstract
Abstract
The wire electrical discharge machining behaviour of alumina particle and short fibre reinforced aluminium based composites was studied. Under the two cutting conditions of this study, namely coarse and fine cutting, the average surface roughness R a of the particle reinforced composite was found always to be higher than that of the corresponding machined matrix surfaces, however, the opposite was found to be true for the fibre reinforced composite. Comparing the surface quality of the two composites, in terms of roughness measurements, the fibre reinforced composite was superior to the particle reinforced composite. Although cutting conditions have little effect on the overall R a of the two composites, their corresponding surface topographies were found to be intrinsically different. Surface banding was observed on the fine cut surfaces of the particle reinforced specimens, which was believed to be caused by shifting of the wire. Based on the machined surface morphology and the measured surface profiles, the material removal mechanism for the two reinforced composites is discussed. MST/3412
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Aluminum Alloys Composites Properties · Advanced Machining and Optimization Techniques · MXene and MAX Phase Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (10)
Show source-provided references
1. 10.1007/BF0115467310.1007/BF01154673 ↗
2. LAWLEY A. and APELIAN D.: Powder Metall. 1994 37 123–128.10.1179/pom.1994.37.2.123 ↗
3. CHADWICK G. A. and YUE T. M.: Met. Mater. 1989 6–12.
4. CHADWICK G. A. and HEATH P. J.: Met. Mater. 1990 73–76.
5. CHEN P.: Ann. Int. Inst. Prod. Eng. Res. (CIRP), 1992,41, 59–62.
6. MASUZAWA T., , FUJINO M., , KOBAYASHI K., , and SUZUKI T.: Ann. Int. Inst. Prod. Eng. Res. (CIRP), 1985, 34, 431–434.
7. MASAKI T. KAWATA K. SATO T. and MASUZAWA T.: in Proc. Conf. ‘Micro electro mechanical systems’ Napa Valley CA USA February 1990 IEEE 21-26.
8. 10.1007/BF0114880510.1007/BF01148805 ↗
9. FELLONI L., , GATTO A., , IPPOLITO R., , and LULIANO L.: Eng. Syst. Des. Anal., 1994,2, 79–85.
10. MONNO M., , SEMERARO Q., , and VENIALI F.: Eng. Syst. Des. Anal., 1994,2, 87–91.