journal article·2002-12

Effect of cooling rate on microstructure of Ti-6Al-4V forging

O. N. Senkov, J. J. Valencia, S. V. Senkova, M. Cavusoglu, F. H. Froes

Materials Science and Technology· Volume 18· Issue 12
Publisher page

Abstract

The objectives of this work were to study the microstructural changes and tensile properties that resulted from controlled cooling of a Ti-6Al-4V alloy that had been pancake forged. The alloy was forged at 954°C and specimens cut from the forging were annealed at 975°C for 30 min and cooled down to room temperature at different cooling rates ranging from 20 K min-1 to 490 K min-1. The specimens had a duplex microstructure consisting of elongated primary α particles and secondary finer α lamellae with some residual β phase layers between them. The average length and width of primary α particles decreased and the aspect ratio and volume fraction of particles increased when the cooling rate was increased. The average lamellar spacing decreased from about 1 μm to 0.3 μm when the cooling rate increased from 25 K min-1 to 490 K min-1. Lamellar α contained 3.0 - 5.2 wt-%Al and 1.4 - 2.1 wt-%V, while the β layers contained 1.4 - 2.8 wt-%Al, 12 - 18 wt-%V and 1.5 - 2.4 wt-%Fe. In the α lamellae, the concentration of aluminium increased and the concentration of vanadium went through a minimum with an increase in cooling rate. In the β layers, the concentration of aluminium increased, while the concentration of vanadium decreased with increasing cooling rate. The volume fraction of the β phase decreased from 10 - 12% to 4 -5% as the cooling rate increased from 25 to 490 K min-1. The tensile strength increased by approximately 7% when increasing the cooling rate from 25 to 370 K min-1, while the reduction in area achieved a 29% peak increase when the cooling rate was increased from 25 to approximately 325 K min-1. A discussion of the effects of cooling rate on microstructure and properties is also given.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Titanium Alloys Microstructure and Properties · Metallurgy and Material Forming · Aluminum Alloy Microstructure Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (7)

Show source-provided references
1. R. BOYER, G. WELSCH, and E. W. COLLINGS: ‘Materials properties handbook: titanium alloys’; 1994, Materials Park, Ohio, ASM.
2. S. R. SEAGLE and L. J. BARTLE: in ‘Source book: titanium and titanium alloys’, (ed. M. J. Donachie, Jr), 23; 1982, Metals Park, Ohio, ASM.
3. E. W. COLLINGS: ‘Physical metallurgy of titanium alloys’; 1984, Metals Park, Ohio, ASM.
4. 10.1080/1042691000891300710.1080/10426910008913007 ↗
5. SEMIATIN S. L. · MetalL Mater. Trans A · 2001 · 32 · 1787 — 1800
6. 10.2320/matertrans1960.26.40510.2320/matertrans1960.26.405 ↗
7. M. J. PHILIPPE in ‘Titanium '95, science and technology’, (ed. P. A. Blenkinsop et al), Vol. 2, 956; 1996, London, The Institute of Materials.