Precipitation sequence for simultaneous continuous and discontinuous modes in Cu–Be binary alloys
Source abstract
Abstract
The precipitation sequence of the discontinuous and continuous modes in Cu–0·9Be and Cu–1·4Be binary alloys (compositions in wt-%) has been studied primarily via metallographic observations and hardness measurements. A single C curve and triple C curves separated by two temperatures T 1 and T 2 (T 1 >T 2 ) are obtained for the precipitation of discontinuous and continuous modes, respectively. The triple C curves correspond to the formation of γ, γ′, and Guinier–Preston (GP) zones. The precipitation sequence of these two precipitation modes and the cell growth behaviour are different for the following three temperature ranges defined by the triple C curves: (i) above T 1 , discontinuous precipitation occurs before the continuous precipitation of γ phase, and the cell growth rate G decreases abruptly; (ii) between T 1 and T 2 , the precipitation sequence is similar to that above T 1 , but G decreases and interlamellar spacing increases progressively with aging time; (iii) below T 2 , GP zones, fine γ″, and/or fine γ′ form before cell growth but the associated variation in G is not observed. The effect of continuous precipitation on the cell growth behaviour is discussed. MST/1647
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Microstructure and mechanical properties · Aluminum Alloy Microstructure Properties · Metallurgy and Material Forming
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (20)
Show source-provided references
1. RIOJA R. J. and LAUGHLIN D. E.: Acta Metall. 1980 28 1301-1313.10.1016/0001-6160(80)90086-3 ↗
2. GUY A. G. BARRETT C. S. and MEHL R. F.: Trans. AIME 1948 175 216-239.
3. TSUBAKINO H. NOZATO R. and HAGIWARA H.: Trans. Jpn Inst. Met. 1981 22 153-162.10.2320/matertrans1960.22.153 ↗
4. 10.2320/jinstmet1952.44.2_13110.2320/jinstmet1952.44.2_131 ↗
5. BORCHERS H. and SCHULZ H.: Acta Metall. 1976 24 639–650.10.1016/0001-6160(76)90084-5 ↗
6. KREYE H.: Z. Metallkd., 1971, 62, 557–562.
7. ENTWISLE A. R., and WYNN J. K.: J. Inst. Met., 1960-1961, 89, 24–29.
8. 10.1179/mst.1986.2.2.12210.1179/mst.1986.2.2.122 ↗
9. BONFIELD W. and EDWARDS B. C.: J. Mater. Sci. 1974 9 398-408 and 409-414.10.1007/BF00737840 ↗
10. TSUBAKINo H. and NOZATO R.: in ‘Solid -.solid phase transform-ations’ (ed. Aaronson H. I. et al.) 951–955; 1982 Warrendale PA TMS-AIME.
11. REINBACH R., and DORFURT U. W.: Z. Meta1141., 1961, 52, 186–191.
12. 10.2320/jinstmet1952.37.6_57110.2320/jinstmet1952.37.6_571 ↗
13. 10.2320/jinstmet1952.35.3_18310.2320/jinstmet1952.35.3_183 ↗
14. 10.1007/BF0287369210.1007/BF02873692 ↗
15. TSUMURAYA K.: Acta Metall. 1982 30 1697–1704.10.1016/0001-6160(82)90191-2 ↗
16. CAHN J. W.: Acta Metall. 1959 7 18–28.10.1016/0001-6160(59)90164-6 ↗
17. ZENER C.: Trans. AIME, 1946, 167, 550–595.
18. TURNBULL D.: in Proc. Conf. ‘Defects in crystalline solids’ 203-211; 1955 London The Physical Society.
19. WILLIAMS D. B., and BUTLER E. P.: int. Met. Rev., 1981, 26, (3), 153–183.
20. AARONSON H. I. and CLARK J. B.: Acta Metall. 1968 16 845–855.10.1016/0001-6160(68)90104-1 ↗