journal article·1996-03

High strength aerospace casting alloys: quality factor assessment

T. Din, A. K. M. B. Rashid, J. Campbell

Materials Science and Technology· Volume 12· Issue 3
Publisher page

Abstract

Over the past two decades there has been increasing interest in the use of the concept of a quality factor Q, introduced by Drouzy and co-workers, as a single parameter for assessing the ‘quality’ of Al alloys. This quality factor is defined as Q=σUTS+150 log E, where σUTS is the ultimate tensile strength and E is the elongation, and has so far been used mainly for the description of the Al–7Si–Mg alloys A356 and A357. The current study was carried out to assess whether the concept could be extended to the higher strength Al–4·5Cu casting alloys A201 and A206. It was concluded that the quality factor does not apply to A201 and A206 in an analogous manner, and thus the concept is not transferable at the present time. It is recommended that the use of the quality factor for A201 and A206 be discontinued until it has been more fully investigated. In the meantime, an alternative definition, Q= σ0·2+kE, where σ0·2 is the 0·2% proof strength, as proposed in the present paper, seems useful and appropriate. This new definition may have wider applicability, but requires further investigation. The use of σ0·2 versus E maps is recommended to encompass the whole range of properties of interest to the designer. The area defined by σ0·2× E, and clearly shown on the σ0·2 versus E map, is proportional to the energy required for ductile fracture. This is revealed to be over an order of magnitude greater in A201 than in A356 and A357 alloys.MST/3279
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Metal Forming Simulation Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (2)

Show source-provided references
1. DIN T. · Mater. Sci. Technol
2. SHIVKUMAR S. · Trans. AFS · 1990 · 98 · 905