journal article·2002-08

Shot peening process: modelling, verification, and optimisation

R. W. Evans

Materials Science and Technology· Volume 18· Issue 8
Publisher page

Abstract

AbstractAbstractThe paper describes the shot peening process and derives expressions for the indentation of surfaces by single shot impacts. These are supplemented by analysis of surface coverage and an assessment of the sources of residual stress. The high strain rate mechanical properties of 5052 aluminium alloy, 316 stainless steel and Ti–6Al–4V have been measured for use in a FEM/DEM simulation model. Specimens of these alloys have also been shot peened and examination of their surfaces has allowed an estimate of shot velocity to be made. Simulations of the process have been compared with diffraction scanning measurements of residual stress profiles and the correlation between the data is good. Procedures for optimising the shot peening process have been proposed.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Welding Techniques and Residual Stresses · Surface Treatment and Residual Stress · Advanced Surface Polishing Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (8)

Show source-provided references
1. D. TABOR: ‘The hardness of metals’; 1951, Oxford, Clarendon Press.
2. AL-OBAID Y. F. · Mech. Mater · 1994 · 19 · 251 —260
3. EVANS R. W. · Met. Technol · 1980 · 17 · 142 — 145
4. 10.1115/1.342778510.1115/1.3427785 ↗
5. HAN K. · Eng. Cornput · 2000 · 17 · 593
6. HAN K. · Eng. Comput · 2000 · 17 · 680 — 702
7. 10.1179/02670830110151084310.1179/026708301101510843 ↗
8. 10.1179/02670830110150998010.1179/026708301101509980 ↗