journal article·2008-11

Comparative experimental study on effects of conventional and ultrasonic deep cold rolling processes on Ti–6Al–4V

A. T. Bozdana, N. N. Z. Gindy

Materials Science and Technology· Volume 24· Issue 11
Publisher page

Abstract

The present paper presents the experimental studies on the treatment of Ti–6Al–4V using conventional and ultrasonic deep cold rolling (CDCR and UDCR) processes. The UDCR process is a novel technique in which the ultrasonic technology was incorporated into the concept of the CDCR process, which enables use of superimposed dynamic forces onto considerably reduced static forces applied on a part surface during treatments by UDCR. Considerable improvements in surface topography and near surface characteristics of treated material were achieved in the present study. Both processes exhibited comparable results in surface finish and induced compressive residual stresses, while the UDCR process produced superior results than the CDCR process in work hardening. The investigations suggest that the UDCR process could provide technological benefits for the treatment of thin walled aerospace components to be carried out without geometry distortion, which would lead to improved fatigue life and resistance to failure mechanisms.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Surface Treatment and Residual Stress · Metal Alloys Wear and Properties · Erosion and Abrasive Machining

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (14)

Show source-provided references
1. 10.1108/0002266051060634910.1108/00022660510606349 ↗
2. Altenberger I. · Mater. Sci. Forum, 2002, 404-407 · 457
3. 10.1016/S0921-5093(03)00069-810.1016/S0921-5093(03)00069-8 ↗
4. Noster U., Altenberger I., Ritchie R. O., and Scholtes B.: Proc. 8th Int. Conf. on ‘Shot peening (ICSP-8)’, Munich, Germany, September 2002, 447-453, Wiley-VCH.10.1002/3527606580.ch57 ↗
5. Altenberger I., Noster U., Scholtes B., and Ritchie R. O.: Proc. 8th Int. Conf. on ‘Shot peening (ICSP-8)’, Munich, Germany, September 2002, 483-489, Wiley-VCH.10.1002/3527606580.ch62 ↗
6. 10.4028/www.scientific.net/MSF.490-491.32810.4028/www.scientific.net/MSF.490-491.328 ↗
7. Marakov A. I. · Eng · 1973 · 1 · 58
8. Hu D. Q., and Fan F. X.: Proc. 1 1 th Int. Conf. on ‘Production research (ICPR-11)’, (ed.Ming L.), Hefei, China, August 1991, 1023-1028, Taylor and Francis, London and China Machine Press.
9. Wang Y. · J. Dalian Univ. Technol · 1994 · 34 · 573
10. Han C. H. · J. Adv. Technot Mater. Mater. Process · 2002 · 4 · 25
11. 10.1016/j.ijmachtools.2004.09.01710.1016/j.ijmachtools.2004.09.017 ↗
12. Ecoroll-AG Werkzeugtechnik, Germany, available at: www.ecoro11.de
13. Lambda Technologies USA, available at: www.lambdatechs.com
14. Hasegawa S.: Manuf Eng. 2001, 126, 70–78.