journal article·2014-12

Influence of elevated Co and Ti levels on polycrystalline powder processed Ni-base superalloy

N. G. Jones, K. A. Christofidou, P. M. Mignanelli, J. P. Minshull, M. C. Hardy, H. J. Stone

Materials Science and Technology· Volume 30· Issue 15
Publisher page

Abstract

The influences of elevated Co and Ti levels on the mechanical properties of the Ni-base superalloy RR1000 have been investigated. Following heat treatment, the modified alloys had the typical γ–γ′ microstructure, with γ′ precipitate sizes comparable to similarly heat treated RR1000, but with a slightly higher volume fraction. The modified alloys exhibited a higher proof stress than RR1000 across the entire 20 to 800°C temperature range investigated. Superior creep rupture lives, when compared to RR1000, were observed in the modified alloys at 700°C, but not at 750°C, where extensive precipitation of topologically close packed σ phase occurred on the grain surfaces. The formation of this deleterious phase was linked to Cr and Mo enrichment of the γ matrix, caused by the elevated Co and Ti additions.
Source: crossref · Quality: baseline

Research context

OpenAlex topics: High Temperature Alloys and Creep · Advanced Materials Characterization Techniques · Intermetallics and Advanced Alloy Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

Affiliations

Department of Materials Science and Metallurgy, University of Cambridge, Cambridge CB3 0FS, UK

Rolls-Royce plc, PO Box 31, Derby DE24 8BJ, UK

References (41)

Show source-provided references
1. ‘European aeronautics: A vision for 2020’, European Commission, 2001.
2. ‘Flightpath 2050: Europe's vision for aviation’, European Commisson, 2011.
3. Decker RF: ‘Strengthening mechanisms in nickel-base superalloys’, in ‘Steel strengthening mechanisms’, 147–170; 1969, Greenwich, CT, Climax Molybdenum Co.
4. 10.1179/03063458479042010410.1179/030634584790420104 ↗
5. 10.1007/BF0266264210.1007/BF02662642 ↗
6. 10.1179/msc.1970.4.1.12110.1179/msc.1970.4.1.121 ↗
7. Fountain RW · Trans. Metall. Soc. AIME · 1959 · 215 · 998
8. Birbring H · Comptes rendus hebdomadaires des séances de l'Académie des Sciences · 1959 · 249 · 1508
9. Viatour P · Cobalt · 1972 · 3 · 67
10. Blaise JM · Cobalt · 1970 · 49 · 192
11. Viatour P · Cobalt · 1971 · 51 · 67
12. 10.1016/j.intermet.2008.04.00610.1016/j.intermet.2008.04.006 ↗
13. Cui C · Metall. Mater. Trans. A · 2005 · 36 · 292110.1007/s11661-005-0065-8 ↗
14. 10.1016/j.scriptamat.2006.07.00810.1016/j.scriptamat.2006.07.008 ↗
15. 10.1016/j.msea.2007.08.04710.1016/j.msea.2007.08.047 ↗
16. 10.2320/matertrans.MBW20070310.2320/matertrans.MBW200703 ↗
17. 10.1007/s11661-008-9746-410.1007/s11661-008-9746-4 ↗
18. 10.1007/BF0258615210.1007/BF02586152 ↗
19. Mitchell RJ: ‘Development of a new powder processed Ni-base superalloy for rotor disc application’, PhD thesis, University of Cambridge, UK, 2004.
20. Boettinger WJ, Kattner UR, Moon K.W and Perepezko JH: ‘DTA and heat-flux DSC measurements of alloy melting and freezing’, 960-15, NIST, 2006.10.1016/B978-008044629-5/50005-7 ↗
21. Minshull J: ‘A1-L12 alloys based on the Al-Co-Ni-Ti quaternary system’, PhD thesis, University of Cambridge, UK, 2010.
22. Connor LD: ‘The development of a dual microstructure heat treated Ni-base superalloy for turbine disc applications’, PhD thesis, University of Cambridge, UK, 2009.
23. 10.1016/j.actamat.2013.09.01810.1016/j.actamat.2013.09.018 ↗
24. 10.1007/BF0264783210.1007/BF02647832 ↗
25. 10.1007/s11661-009-9858-510.1007/s11661-009-9858-5 ↗
26. 10.1016/S0921-5093(98)00867-310.1016/S0921-5093(98)00867-3 ↗
27. Miodownik A and Saunders N: in ‘Application of thermodynamics in the synthesis and processing of materials’, (ed. Nash P et al.), 91–104; 1995, Warrendale, PA, The Minerals, Metals and Materials Society.
28. Bragg W · Proc. R. Soc. A · 1934 · 145 · 699
29. 10.1002/pssb.1966016023410.1002/pssb.19660160234 ↗
30. 10.1016/0036-9748(70)90230-910.1016/0036-9748(70)90230-9 ↗
31. 10.1007/BF0264356910.1007/BF02643569 ↗
32. 10.4028/www.scientific.net/MSF.189-190.34710.4028/www.scientific.net/MSF.189-190.347 ↗
33. 10.1016/0001-6160(75)90091-710.1016/0001-6160(75)90091-7 ↗
34. 10.1016/0079-6425(85)90001-510.1016/0079-6425(85)90001-5 ↗
35. 10.1016/0956-7151(92)90022-710.1016/0956-7151(92)90022-7 ↗
36. 10.1179/03063457879043403410.1179/030634578790434034 ↗
37. 10.1557/jmr.2011.34610.1557/jmr.2011.346 ↗
38. 10.1007/s11661-999-0044-610.1007/s11661-999-0044-6 ↗
39. 10.1016/S1359-6454(01)00265-810.1016/S1359-6454(01)00265-8 ↗
40. Wang WZ · Mater. Sci. Eng. A · 2008 · 479 · 148
41. Lund CH, Woulds MJ and Hockin J: ‘Cobalt and sigma: Participant, spectator, or referee?’, Proc. Int. Symp. on ‘Structural stability in superalloys’, Seven Springs, PA, USA, September 1968, AIME, 25–46.10.7449/1968/Superalloys_1968_26_46 ↗