Tailoring Ca0.99Ce0.01MnO3 properties using Mo doping and its integration in a power generation thermoelectric module
Source abstract
Abstract
In the present study, we examined both the crystal structure and thermoelectric behavior of Ca0.99Ce0.01Mn1-xMoxO3 compositions, with Mo concentrations set at x = 0, 0.01, 0.03, 0.05, and 0.10. From XRD experiment, it is observed that most of the peaks can be indexed in a Pnma space group. Furthermore, Mo has effectively substituted Mn into the unit cell revealed by the shift of the diffraction peaks towards lower angles. SEM images showed a grain refinement with the increase in Mo doping, suggesting that it acts as grain growth inhibitor. Moreover, a decrease of porosity is observed when the amount of dopant is raised up to 0.05, increasing for higher Mo content. EDS analysis conducted on various regions of the samples shows that the grain compositions closely match the nominal values. Resistivity data show that the undoped sample exhibits both metallic-like and semiconducting-like behavior, whereas Mo doping induces metallic-like behavior throughout the entire temperature range. The lowest resistivity at 800 °C (∼ 6.5 mΩ cm) was recorded for the 0.10 Mo-substituted sample, which is comparable to the values found in the 0.03 and 0.05 Mo-doped samples, and significantly lower than that of the undoped sample. The evolution of the Seebeck coefficient as a function of composition and temperature demonstrated that all samples exhibit negative S values within the measured range of temperatures. The highest |S| values at 800 °C were measured in the Mo-free samples (213 μV/K), very close to that of the 0.01Mo-doped samples (207 μV/K). Highest PF measured at 800 °C were obtained in 0.01Mo-doped samples (∼ 0.36 mW/K2m), which are between 13 and 30 % higher than those obtained in 0.0, 0.03, and 0.05Mo-doped samples. Finally, a power generation thermoelectric module with 17 p-n pairs, and 50 × 50 mm2 surface, has been successfully prepared using 0.01Mo doped samples and Ca2.93Sr0.07Co4O9, which has produced 0.045 W maximum power at 900 °C hot-side temperature, under 358 °C internal ΔT. Taking into account the module surface (2500 mm2) and the maximum power generated (45 mW), a high power density of 18 W/m2 has been obtained.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced Thermoelectric Materials and Devices · Magnetic and transport properties of perovskites and related materials · Thermal Expansion and Ionic Conductivity
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (64)
Show source-provided references
1. Complex thermoelectric materials10.1038/nmat2090 ↗
2. Reducing energy demand: a review of issues, challenges and approaches10.1016/j.rser.2015.03.002 ↗
3. The path towards sustainable energy10.1038/nmat4834 ↗
4. Design of a thermoelectric generator for waste heat recovery application on a drivable heavy-duty vehicle10.4271/2017-01-9178 ↗
5. Field test of a geothermal thermoelectric generator without moving parts on the hot dry rock field of Timanfaya National Park10.1016/j.applthermaleng.2022.119843 ↗
6. Abundances of chemical elements in the earth’s crust10.1134/S001670290601006X ↗
7. Development of multilayer textured Ca3Co4O9 materials for thermoelectric generators: influence of the anisotropy on the transport properties10.1016/j.jeurceramsoc.2012.03.022 ↗
8. Misfit-layered cobaltite with an anisotropic giant magnetoresistance: Ca3Co4O910.1103/PhysRevB.62.166 ↗
9. Significant enhancement of the thermoelectric performance in Ca3Co4O9 thermoelectric materials through combined strontium substitution and hot-pressing process10.1016/j.jeurceramsoc.2018.12.049 ↗
10. Thermoelectric generators: linking material properties and systems engineering for waste heat recovery applications
11. High temperature thermoelectric response of electron-doped CaMnO310.1021/cm901766y ↗
12. Right heterogeneous microstructure for achieving excellent thermoelectric performance in Ca0.9R0.1MnO3-δ (R = Dy, Yb) ceramics10.1021/acs.inorgchem.8b01163 ↗
13. Influence of rare-earth elements doping on thermoelectric properties of Ca0.98Dy0.02MnO3 at high temperature10.1016/j.jssc.2014.12.010 ↗
14. Preparation and improved electrical performance of the Pr-doped CaMnO3-δ thermoelectric compound10.1088/0031-8949/88/03/035705 ↗
15. Large thermoelectric power in NaCo2O4 single crystals10.1103/PhysRevB.56.R12685 ↗
16. Thermoelectric ceramics for generators10.1016/j.jeurceramsoc.2007.05.012 ↗
17. Fabrication of ca-Mn-Nb-O compounds and their structural, electrical, magnetic and thermoelectric properties10.1088/2053-1591/aab3af ↗
18. Effect of A- or B-site doping of perovskite calcium manganite on structure, resistivity, and thermoelectric properties10.1111/jace.15015 ↗
19. High temperature thermoelectric properties of Ca1−xBixMn1−yVyO3−δ (0≤x=y≤0.08)10.1016/j.ssc.2007.10.012 ↗
20. Significant reduction in processing time for Ca0.95Ce0.05MnO3 thermoelectric ceramics10.1016/j.ceramint.2023.09.107 ↗
21. Effect of Y, La, and Yb simultaneous doping on the thermal conductivity and thermoelectric performances of CaMnO3 ceramics10.1016/j.jallcom.2023.170201 ↗
22. Effect of B-site doping on the thermoelectric performances of Ca0.97Y0.01La0.01Yb0.01Mn1-2xNbxMoxO3 thermoelectric ceramics10.1016/j.jeurceramsoc.2023.12.067 ↗
23. Insights into the structural, microstructural and thermoelectric properties of Ce/Cr co-doped CaMnO3 manganites10.1007/s10854-025-15116-z ↗
24. Phase separated behavior in yttrium doped CaMnO310.1016/j.materresbull.2016.02.007 ↗
25. Magnetic study of the Manganate phases: CaMnO3, Ca4Mn3O10, Ca3Mn2O7, Ca2MnO4
26. Low temperature magnetic properties of Gd doped CaMnO3, chemical data
27. Evidence of weak ferromagnetism, space charge polarization, and metal to insulator transition in Dy- doped CaMnO310.1007/s10948-020-05770-1 ↗
28. WinPLOTR, a graphic tool for power diffraction pattern analysis
29. Short reports from the metallurgical and metallographical laboratory of the Royal Mechanical and technical testing Institute of Charlottenburg
30. Effect of synthesis methods on the Ca3Co4O9 thermoelectric ceramic performances10.1016/j.jssc.2014.10.015 ↗
31. Structure determination of CaMnO3 and CaMnO2.5 by X-ray and neutron methods10.1016/0022-4596(82)90292-4 ↗
32. Thermoelectrical properties of A-site substituted Ca1−xRexMnO3 system10.1063/1.2362922 ↗
33. High temperature metal-insulator transition induced by rare-earth doping in perovskite CaMnO310.1021/jp809049s ↗
34. Tunable thermoelectric properties of Ca0.9Yb0.1MnO3 through controlling the particle size via ball mill processing10.1016/j.ceramint.2014.08.033 ↗
35. Electrical properties of Dy3+/Na+ co-doped oxide thermoelectric [Ca1-x(Na1/2Dy1/2)x]MnO3 ceramics10.1016/j.jallcom.2016.04.158 ↗
36. Effects of Dy and Yb co-doping on thermoelectric properties of CaMnO3 ceramics10.1016/j.ceramint.2014.09.089 ↗
37. Thermoelectric Ca0.9Yb0.1MnO3−δ grain growth controlled by spark plasma sintering10.1016/j.jeurceramsoc.2013.02.003 ↗
38. Growth rate effects on the thermoelectric performance of CaMnO3-based ceramics10.1016/j.jeurceramsoc.2019.06.011 ↗
39. Tuning thermoelectric properties of Ca0.9Gd0.1MnO3 by laser processing10.1007/s10854-020-04428-x ↗
40. Improved thermoelectric performance in Pr and Sr co-doped CaMnO3 materials10.1016/j.jallcom.2019.07.188 ↗
41. Metal−insulator transition induced by Ce doping in CaMnO310.1021/cm040188b ↗
42. The effect of Fe doping on structural, magnetic and electrical transport properties of CaMn1−xFexO3 (x=0–0.35)10.1016/j.ssc.2007.03.021 ↗
43. Flahaut · 2006 · 103
44. Enhancement of thermoelectric efficiency in PbTe by distortion of the electronic density of states10.1126/science.1159725 ↗
45. Role of ag in textured-annealed Bi2Ca2Co1.7Ox thermoelectric ceramic10.1016/j.actamat.2015.09.036 ↗
46. CaMn1-xNbxO3 (x ≤ 0.08) perovskite-type phases as promising new high-temperature n-type thermoelectric materials10.1021/ic800463s ↗
47. Effects of Gd doping on microwave absorption properties and mechanism for CaMnO3 perovskites10.1016/j.ceramint.2023.04.183 ↗
48. Synthesis and thermoelectric properties of Yb-doped Ca0.9-xYbxLa0.1MnO3 ceramics10.1007/s11664-014-3326-8 ↗
49. Synthesis of Dy doped Yb0.1Ca0.9MnO3 ceramics with a high relative density and their thermoelectric properties10.1016/j.materresbull.2012.05.061 ↗
50. Influence of Dy/bi dual doping on thermoelectric performance of CaMnO3 ceramics10.1016/j.matchemphys.2014.01.006 ↗
51. Recent developments in nanostructured materials for high-performance thermoelectrics10.1039/c0jm01193b ↗
52. Crystal structure and thermoelectric properties of Sr–Mo substituted CaMnO3: a combined experimental and computational study10.1039/C5TC02318A ↗
53. Grain boundary phase segregation for dramatic improvement of the thermoelectric performance of oxide ceramics10.1021/acsami.8b12710 ↗
54. Cross-scale porous structure design leads to optimized thermoelectric performance and high output power for CaMnO3 ceramics and their uni-leg modules
55. Thermoelectric and magnetic properties of Ca0.98Re0.02MnO3-δ (re=Sm, Gd and Dy)10.1007/s11664-012-2159-6 ↗
56. Rapid reactive synthesis and sintering of textured Ca3Co4O9 ceramics by spark plasma sintering10.1016/j.jmatprotec.2007.12.093 ↗
57. Fabrication and thermoelectric properties of Ca3-xDyxCo4O9+δ system10.1016/j.jallcom.2003.12.018 ↗
58. Enhancement of high temperature thermoelectric performance in bi, Fe co-doped layered oxide-based material Ca3Co4O9+δ10.1016/j.jallcom.2014.06.190 ↗
59. Fabrication and thermoelectric properties of highly textured Ca9Co12O28 ceramic10.1016/j.jallcom.2013.07.145 ↗
60. Tailoring Ca3Co4O9 microstructure and performances using a transient liquid phase sintering additive10.1016/j.jeurceramsoc.2015.11.024 ↗
61. Fabrication and testing of ceramic thermoelectric multi-leg module for high-temperature energy conversion10.1016/j.jallcom.2025.178628 ↗
62. Phase equilibria in ca–co–O system10.1016/j.jssc.2012.05.014 ↗
63. Power generation of a p-type Ca3Co4O9/n-type CaMnO3 module10.1111/j.1744-7402.2007.02173.x ↗
64. Monolithic thermoelectric devices prepared with multilayer Cofired ceramics technology10.1143/JJAP.49.096505 ↗