journal article·2023-08

Nanosecond pulsed laser annealing of Cu/Ag/AZO multilayer thin films for performance improvement and transparent heater application

Bao-jia Li, Zhi-xiang Li, Lin Wang, Li-jing Huang

Publisher page

Abstract

Nanosecond pulsed laser annealing was performed to improve optical and electrical properties of the Cu/Ag/AZO multilayer films. Different laser fluences ( L) and scanning speeds ( S) were selected to investigate their influences on optical transparency and electrical conductivity of the films. The results revealed that laser annealing under L = 1.0 J/cm 2 and S = 10 mm/s effectively promoted grain growth in the film and caused formation of significantly enlarged particles with a more uniform distribution on the film surface. The as-obtained Cu/Ag/AZO multilayer film possessed the optimal comprehensive property with the highest figure of merit of 3.58 × 10 –2 Ω −1, far outperforming the unannealed Cu/Ag/AZO multilayer film (1.92 × 10 –2 Ω −1). Subsequently, this film was chosen to fabricate a transparent heater, which exhibited excellent heating performance (saturated temperature: 104.9 ℃; response time: 120 s; applied voltage: 5 V) and heating stability. Its deicing availability was also shown by a deicing test.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: ZnO doping and properties · Copper-based nanomaterials and applications · Nanomaterials and Printing Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (66)

Show source-provided references
1. Transparent conducting oxide semiconductors for transparent electrodes10.1088/0268-1242/20/4/004 ↗
2. Arrangement of AZO-CZO n-p heterojunction thin film by electrospinning method; microstructural study and photocatalytic properties10.1016/j.mseb.2020.114939 ↗
3. Optical and electrical properties of Al doped ZnO thin film with preferred orientation in situ grown at room temperature10.1016/j.ceramint.2019.04.149 ↗
4. Preparation of RF sputtered AZO/Cu/AZO multilayer films and the investigation of Cu thickness and substrate effects on their microstructural and optoelectronic properties10.1016/j.jallcom.2020.158470 ↗
5. Large-area self-assembled reduced graphene oxide/electrochemically exfoliated graphene hybrid films for transparent electrothermal heaters10.1016/j.apsusc.2017.11.182 ↗
6. Transparent heater based on Al, Ga co-doped ZnO thin films10.1016/j.matlet.2018.11.092 ↗
7. Copper/silver composite mesh transparent electrodes with low reflection for high-performance and low-voltage transparent heaters10.1016/j.jallcom.2021.158877 ↗
8. Fabrication and performances of silver grid transparent conducting films and heaters on glass and PET substrates based on fractal periodic grid pattern design
9. Flexible transparent Ag nanowire/UV-curable resin heaters with ultra-flexibility, high transparency, quick thermal response, and mechanical reliability10.1016/j.jallcom.2022.164690 ↗
10. The Ag layer thickness effect on the figure of merit of the AZO/Ag bilayer prepared by DC sputtering of AZO and thermal evaporation method of Ag
11. Utilization of AZO/Au/AZO multilayer electrodes instead of FTO for perovskite solar cells10.1016/j.solmat.2017.01.008 ↗
12. Enhanced electrical properties of platinum spotted AZO/PET thin films prepared by sol–gel process10.1166/jnn.2020.17272 ↗
13. Preparation of AZO/Cu/AZO films with low infrared emissivity, high conductivity and high transmittance by adjusting the AZO layer10.1016/j.apsusc.2021.152051 ↗
14. Structure and optoelectronic properties of AZO/Al/AZO tri-layer films grown on flexible substrates10.1007/s10854-018-00626-w ↗
15. The influence of Ni layer and thickness of AZO layers on the optoelectronic properties of AZO/Ni/AZO tri-layer deposited at room temperature10.1016/j.matlet.2014.09.001 ↗
16. Effects of BN layer on photoelectric properties and stability of flexible Al/Cu/ZnO multilayer thin film10.1016/j.ceramint.2020.02.272 ↗
17. Highly stable silver nanowire networks with tin oxide shells for freestanding transparent conductive nanomembranes through all-solution processes10.1016/j.cej.2022.137481 ↗
18. Characteristics of indium-free GZO/Ag/GZO and AZO/Ag/AZO multilayer electrode grown by dual target DC sputtering at room temperature for low-cost organic photovoltaics10.1016/j.solmat.2009.07.016 ↗
19. Growth of AZO/Cu/AZO multilayer structures by confocal RF magnetron sputtering and their microstructural and optoelectronic properties before and after annealing10.1016/j.mseb.2022.115889 ↗
20. Influence of Al/Cu thickness ratio and deposition sequence on photoelectric property of ZnO/Al/Cu/ZnO multilayer film on PET substrate prepared by RF magnetron sputtering10.1016/j.mssp.2018.11.013 ↗
21. Femtosecond laser selective ablation of Cu/Ag double-layer metal films for fabricating high-performance mesh-type transparent conductive electrodes and heaters10.1016/j.optcom.2020.126661 ↗
22. Effect of deposition process parameters on resistivity of metal and alloy films deposited using anodic vacuum arc technique10.1016/j.tsf.2006.06.028 ↗
23. Evaluation of structural properties of AZO conductive films modification using low-temperature ultraviolet laser annealing10.1016/j.ceramint.2019.05.167 ↗
24. Direct laser writing of graphene made from chemical vapor deposition for flexible, integratable micro-supercapacitors with ultrahigh power output10.1002/adma.201801384 ↗
25. Morphology, structure and photoelectric properties of F-doped SnO2 films under flexible PET mask reinforced laser annealing10.1016/j.mssp.2021.105853 ↗
26. Laser assisted wet texturing of flexible polyethylene terephthalate substrate using Nd3+:YAG laser for photovoltaics devices10.1016/j.mseb.2017.08.028 ↗
27. Effects of laser irradiation on the structure and optical properties of ZnO thin films10.1016/j.matlet.2010.06.022 ↗
28. CO2 laser annealing effects for Al-doped ZnO multilayered films10.1016/j.ceramint.2018.08.112 ↗
29. Performance optimization of SnO2: F thin films under quasi-vacuum laser annealing with covering a transparent PET sheet: A study using processing map10.1016/j.apsusc.2020.145334 ↗
30. Laser annealing process of ITO thin films using beam shaping technology10.1016/j.optlaseng.2011.10.002 ↗
31. Electrode patterning and annealing processes of aluminum-doped zinc oxide thin films using a UV laser system10.1016/j.optlaseng.2012.08.003 ↗
32. Ultrafast laser direct writing on PVP/FTO/Glass substrates to fabricate Ag mesh transparent conductive films10.1016/j.ceramint.2021.01.279 ↗
33. Effect on structural, optical and electrical properties of aluminum-doped zinc oxide films using diode laser annealing10.1016/j.optlastec.2014.11.009 ↗
34. Effect on the electro-optical properties of transparent conducting aluminum doped zinc oxide thin films using low temperature ultraviolet laser annealing10.1007/s10854-017-7453-x ↗
35. Silver-enriched ZnO: Ag thin films deposited by magnetron co-sputtering: Post annealing effects on structural and physical properties10.1016/j.mseb.2021.115558 ↗
36. Structural and optoelectronic properties of AZO thin films prepared by RF magnetron sputtering at room temperature10.1016/S1003-6326(16)64275-9 ↗
37. The structural and electro-optical characteristics of AZO/Cr:Cu/AZO transparent conductive film10.1016/j.tsf.2015.06.011 ↗
38. Synthesis and characterisations of Au-nanoparticle-doped TiO2 and CdO thin films10.1016/j.jpcs.2014.01.011 ↗
39. Improving optical and electrical performances of aluminum-doped zinc oxide thin films with laser-etched grating structures10.1016/j.ceramint.2020.11.150 ↗
40. Static electric field enhanced recrystallization of copper phthalocyanine thin film during annealing10.1016/j.jcrysgro.2013.05.040 ↗
41. Influence of annealing temperature on structural, optical and electrical properties of AZO/Pd/AZO films10.1016/j.solmat.2016.04.015 ↗
42. Evolution in morphological, optical, and electronic properties of ZnO: Al thin films undergoing a laser annealing and etching process10.1016/j.solmat.2014.02.027 ↗
43. Preparation and property optimization of silver embedded FTO transparent conductive thin films by laser etching and coating AZO layer10.1007/s10854-021-05720-0 ↗
44. The annealing temperature and films thickness effect on the surface morphology, preferential orientation and dielectric property of NiO films10.1016/j.apsusc.2019.06.223 ↗
45. Improving efficiency of organic light-emitting diodes fabricated utilizing AZO/Ag/AZO multilayer electrode10.1016/j.vacuum.2012.05.028 ↗
46. AZO (Al:ZnO) thin films with high figure of merit as stable indium free transparent conducting oxide10.1016/j.apsusc.2019.02.146 ↗
47. Photoelectric property enhancement of Ag/FTO thin films by fabricating antireflection grating structures using ultrasonic-vibration-assisted laser irradiation10.1016/j.apsusc.2020.148449 ↗
48. Laser annealing effect on optical and electrical properties of Al doped ZnO films10.1016/j.optlastec.2012.06.001 ↗
49. Preparation and photoelectric properties of patterned Ag nanoparticles on FTO/glass substrate by laser etching and driving layer strategy10.1007/s40195-020-01169-y ↗
50. Rapid laser annealing of silver electrodes for printing organic thin-film transistors on plastic substrates10.1109/TED.2019.2911310 ↗
51. Experimental and numerical analysis of surface melt dynamics in 200 ns-excimer laser crystallization of a-Si films on glass10.1016/S0040-6090(00)01627-8 ↗
52. Laser annealing effects on Ga dopants for ZnO thin films for transparent conducting oxide applications10.1016/j.ceramint.2018.12.096 ↗
53. The effect of Ga doping on ZnO thin films subjected to CO2 laser annealing10.1016/j.ceramint.2020.01.064 ↗
54. Influence of annealing temperature on physical properties of Sn-doped CdO thin films by nebulized spray pyrolysis technique10.1016/j.mseb.2019.03.018 ↗
55. Transparent conducting impurity-co-doped ZnO: Al thin films prepared by magnetron sputtering10.1016/S0040-6090(01)01303-7 ↗
56. Effects of atomic oxygen treatment on structures, morphologies and electrical properties of ZnO: Al films10.1016/j.apsusc.2010.02.041 ↗
57. Effect of Ag layer thickness and scan line spacing during laser annealing of Ag/F-doped SnO2 bilayer composite thin films under ultrasonic vibration assistance10.1016/j.jallcom.2020.154504 ↗
58. Structural, electrical, photoluminescence and optical properties of n–type conducting, phosphorus-doped ZnO thin films prepared by pulsed laser deposition10.1016/j.apsusc.2014.01.037 ↗
59. Fabrication of metal mesh flexible transparent electrodes and heaters by a cost-effective method based on ultrafast laser direct writing10.1016/j.optlastec.2020.106867 ↗
60. van der Waals epitaxy of Al-doped ZnO film on mica as a flexible transparent heater with ultrafast thermal response10.1063/1.5010358 ↗
61. Robust ultrathin and transparent AZO/Ag-SnOx/AZO on polyimide substrate for flexible thin film heater with temperature over 400 °C10.1016/j.jmst.2020.01.058 ↗
62. Solution processed aluminum-doped ZnO thin films for transparent heater applications10.1016/j.mssp.2021.105735 ↗
63. Flexible transparent conductive ZnSnO/Cu/ZnSnO multilayer films for flexible transparent heaters
64. Roll-to-Roll sputtered ITO/Cu/ITO multilayer electrode for flexible, transparent thin film heaters and electrochromic applications10.1038/srep33868 ↗
65. High thermal performance of SnO2: F thin transparent heaters with scattered metal nanodots10.1021/am507497u ↗
66. Solution processed glass/fluorine-doped tin oxide/aluminum-doped zinc oxide double layer thin films for transparent heater and near-infrared reflecting applications10.1007/s10971-021-05591-1 ↗