Post-deposition annealing influences of gas adsorption on semi-vertical β-FeOOH nanorods at room temperature: A scanning kelvin probe analysis
Source abstract
Abstract
An investigation on gas adsorption of β-FeOOH at room temperature was performed through kelvin probe analysis. The microscopic images revealed the semi vertically grown nanorods on conductive fluorine doped tin oxide (FTO) substrate prepared by hydrothermal method. The annealing temperature strongly influenced the crystallite size, lattice stress, grain size and boundaries estimated through X-ray diffraction analysis. The crystallite size increased from 57 nm to 67 nm with a proportional increase in annealing temperature from 350 °C to 450 °C. The UV absorption spectra indicated a red shift towards visible wavelength region with increasing annealing temperature elucidating a visible-light enhanced response for the activation of gas adsorption. Correspondingly, the energy band gap decreased with increasing annealing temperature. The adsorption behaviour of different types of volatile organic compounds (VOCs) were studied using scanning kelvin probe (SKP) to measure the contact potential difference (CPD) on the surface of the samples. The CPD changes for ethanol were higher (−264 mV) at lower temperatures (350 °C) and vice versa. However, an intriguing behaviour was found for other types of gases. This peculiar behaviour with respect to the annealing temperature was understood by SKP and attributed to the presence of numerous grain boundaries interfaces which were absent when annealed at low temperature due to higher crystallite size. These adsorption studies provides notion on the fundamental mechanism of gas interaction for the fabrication of selective gas sensors.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Gas Sensing Nanomaterials and Sensors · Analytical Chemistry and Sensors · Transition Metal Oxide Nanomaterials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (39)
Show source-provided references
1. Socio-economic demands and challenges for non-invasive disease diagnosis through a portable breathalyzer by the incorporation of 2D nanosheets and SMO nanocomposites10.1039/D1RA02554F ↗
2. Synergy between nanomaterials and volatile organic compounds for non-invasive medical evaluation10.1039/C8CS00317C ↗
3. Semiconductor metal oxide gas sensors: A review10.1016/j.mseb.2017.12.036 ↗
4. Recent progress in graphene derivatives/metal oxides binary nanocomposites based chemi-resistive sensors for disease diagnosis by breath analysis10.2174/1573411017999201125203955 ↗
5. Synthesis, characterization, applications, and challenges of iron oxide nanoparticles10.2147/NSA.S99986 ↗
6. Iron oxide with different crystal phases (α- and γ-Fe2O3) in electroanalysis and ultrasensitive and selective detection of lead(II): an advancing approach using XPS and EXAFS10.1021/acs.analchem.5b03570 ↗
7. The origin of hematite nanowire growth during the thermal oxidation of iron10.1016/j.mseb.2011.12.034 ↗
8. Alkali concentration effects on the composition, morphology and magnetic properties of magnetite, maghemite and iron oxyhydroxide nanoparticles10.1016/j.solidstatesciences.2020.106295 ↗
9. Colloidal maghemite nanoparticles with oxyhydroxide-like interface and chiroptical properties10.1016/j.apsusc.2020.147567 ↗
10. Nickel nanoparticle-decorated reduced graphene oxide/WO3 nanocomposite – a promising candidate for gas sensing10.3762/bjnano.12.28 ↗
11. Gas sensors based on mechanically exfoliated MoS2 nanosheets for room-temperature NO2 detection10.3390/s19092123 ↗
12. Nanostructured metal oxide-based acetone gas sensors: a review10.3390/s20113096 ↗
13. One-pot hydrothermal method synthesised SnS/rGO nanocomposite under PVDF bonding for high-performance acetone gas sensor10.1016/j.mseb.2020.114861 ↗
14. Advances in chemiresistive sensors for acetone gas detection10.1016/j.mssp.2019.104616 ↗
15. Progressive NO2 sensors with rapid alarm and persistent memory-type responses for wide-range sensing using antimony triselenide nanoflakes10.1002/adfm.202102439 ↗
16. Interfacial ammonia selectivity, atmospheric passivation, and molecular identification in graphene-nanopored activated carbon molecular-sieve gas sensors10.1021/acsami.1c19138 ↗
17. Room-temperature gas sensing of ZnO-based gas sensor: A review10.1016/j.sna.2017.10.021 ↗
18. Visible-light-activated response originating from carrier-mobility modulation of NO2 gas sensors based on MoS2 monolayers10.1021/acsnano.0c06996 ↗
19. Indium content dependent VOCs interactions in monolithic InGaN/GaN multi quantum well structures grown by MOCVD10.1016/j.mssp.2019.104694 ↗
20. Tunable visible light enhanced triethylamine adsorption on pH dependent ZnO nanostructures: An investigation by scanning Kelvin probe
21. Sensing of ammonia at room temperature by polypyrrole-tin oxide nanostructures: Investigation by Kelvin probe force microscopy10.1016/j.sna.2016.05.004 ↗
22. XPS and Kelvin probe studies of SnO2/RGO nanohybrids based NO2 sensors10.1016/j.apsusc.2019.05.176 ↗
23. Vertically oriented iron oxide films produced by hydrothermal process: effect of thermal treatment on the physical chemical properties10.1021/am301425e ↗
24. A simple and novel route for the preparation of ZnO nanorods10.1016/S0038-1098(02)00114-X ↗
25. Effect of sodium nitrate on microwave-assisted synthesis of ceria nanocubes10.1016/j.matlet.2016.04.186 ↗
26. A flexible NO2 gas sensor based on polypyrrole/nitrogen-doped multiwall carbon nanotube operating at room temperature10.1016/j.snb.2019.05.065 ↗
27. Direct correlations among the grain size, texture, and indentation behavior of nanocrystalline nickel coatings10.3390/met9020188 ↗
28. Transparent conducting n-type ZnO: Sc – synthesis, optoelectronic properties and theoretical insight10.1039/C7TC02389H ↗
29. Pt-doped α-Fe2O3 photoanodes prepared by a magnetron sputtering method for photoelectrochemical water splitting10.1016/j.materresbull.2017.03.060 ↗
30. Room temperature CO sensing with metal oxide nanoparticles using work function readout10.1016/j.proeng.2016.11.195 ↗
31. Porphyrin-functionalized zinc oxide nanostructures for sensor applications10.3390/s18072279 ↗
32. Sensing properties of NiO loaded SnO2 nanoparticles—specific selectivity to H2S10.3390/chemosensors9060125 ↗
33. A p- to n-transition on α-Fe2O3-based thick film sensors studied by conductance and work function change measurements10.1016/j.snb.2004.04.075 ↗
34. Effect of Fe modification on H2S sensing properties of rheotaxially grown and thermally oxidized SnO2 thin films10.1016/j.matchemphys.2015.03.006 ↗
35. Fabrication of gas sensor based on mesoporous rhombus-shaped ZnO rod arrays10.1016/j.snb.2014.11.024 ↗
36. Optimization of post-deposition annealing temperature for improved signal-to-noise ratio in In2O3 gas sensor10.1088/1361-6641/abf906 ↗
37. Hydrogen sensing properties of ZnO nanorods: Effects of annealing, temperature and electrode structure10.1016/j.ijhydene.2014.01.066 ↗
38. Comparative study on the preparation and gas sensing properties of reduced graphene oxide/SnO 2 binary nanocomposite for detection of acetone in exhaled breath10.1021/acs.analchem.8b05670 ↗
39. A comparison of online and offline measurement of exhaled breath for diabetes pre-screening by graphene-based sensor; from powder processing to clinical monitoring prototype10.1088/1752-7163/ab09ae ↗