journal article·2007-03

Development of nano-structured Al–Si–Fe based bulk alloys from atomized powders

D.-S. Lee, T.-K. Jung, M.-S. Kim, W.-Y. Kim, H. Yamagata

Publisher page

Abstract

Abstract We report on the microstructure and mechanical properties of nano-structured Al–Si–Fe based bulk alloy prepared using two or three processing steps consisting of the pre-compaction of the powders and subsequent forging, with or without a sintering step. The porosity of the present alloys produced using two or three processing steps could be reduced to less than 0.5% by paying careful attention to the forging temperature. The alloy produced using two processing steps showed a finer microstructure than that fabricated using three processing steps including a sintering stage. The alloy produced using two processing steps showed a yield strength of 490 MPa, which was much higher than that obtained in the alloy produced using three processing steps, without any large sacrificing of ductility.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloys Composites Properties · Metallic Glasses and Amorphous Alloys · Nanoporous metals and alloys

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (5)

Show source-provided references
1. Yamagata · J. Jpn. Inst. Light Metals · 1998 · 48 · 5210.2464/jilm.48.52 ↗
2. Yamagata · Mater. Sci. Forum · 1999 · 304–306 · 79710.4028/www.scientific.net/MSF.304-306.797 ↗
3. Cho · Scripta Mater. · 2000 · 42 · 22110.1016/S1359-6462(99)00335-8 ↗
4. Lee · Mater. Sci. Forum · 2005 · 475–479 · 39310.4028/www.scientific.net/MSF.475-479.393 ↗
5. Villars · 1995