journal article·2004-12

Creep behavior of ceramics studied by mechanical loss measurements

R. Schaller, M. Daraktchiev, S. Testu

Publisher page

Abstract

Abstract Mechanical loss due to grain boundary (GB) sliding has been measured at high temperature in fine-grained yttria-stabilized tetragonal zirconia and silicon nitride. In zirconia, GB sliding gives rise to a mechanical loss peak and exponential background. The transition from the peak to the exponential background accounts for creep appearance in the material. When the amount of inter-granular lubricating glassy phases is higher the mechanical loss level is globally higher and so is the creep rate. When part of the amorphous phase forms amorphous pockets, like in silicon nitride, a mechanical loss peak related to dissipation in these pockets is observed. Silicon nitride sintered under gas pressure contains a very small amount of glassy phase and consequently exhibits a strong resistance to deformation until 1450 °C. As a consequence the mechanical loss background and relaxation peak are very low in the as-sintered material. However, the peak increases after annealing and “quenching” from high temperature. This argues for high temperature melting of the inter-granular crystalline phases, followed by freezing of these liquid phases into the amorphous state upon rapid cooling.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced ceramic materials synthesis · Intermetallics and Advanced Alloy Properties · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (16)

Show source-provided references
1. Wakai · Adv. Ceram. Mater · 1986 · 1 · 25910.1111/j.1551-2916.1986.tb00026.x ↗
2. Boutz · J. Eur. Ceram. Soc · 1994 · 13 · 10310.1016/0955-2219(94)90107-4 ↗
3. Primdahl · Acta Metall. Mater · 1995 · 43 · 121110.1016/0956-7151(94)00307-4 ↗
4. Bravo-Leon · Acta Metall. Mater · 1992 · 40 · 271710.1016/0956-7151(92)90342-C ↗
5. R. Schaller, G. Fantozzi, G. Gremaud (Eds.), Mechanical Spectroscopy Q−1 2001, Mater. Sci. Forum 366–368 (2001).10.4028/www.scientific.net/MSF.366-368.615 ↗
6. Lakki · Acta Metall. Mater · 1993 · 41 · 284510.1016/0956-7151(93)90099-E ↗
7. Lakki · Acta Metall. Mater · 1995 · 43 · 41910.1016/0956-7151(94)00275-M ↗
8. Bernard-Granger · J. Eur. Ceram. Soc · 1997 · 17 · 164710.1016/S0955-2219(97)00008-3 ↗
9. Testu · Key Eng. Mater · 2000 · 171–174 · 81710.4028/www.scientific.net/KEM.171-174.817 ↗
10. Crampon · J. Mater. Sci · 1993 · 28 · 90910.1007/BF00400873 ↗
11. Gadaud · Rev. Sci. Instrum · 1990 · 61 · 267110.1063/1.1141858 ↗
12. Charit · Acta Mater · 2001 · 49 · 223910.1016/S1359-6454(01)00131-8 ↗
13. Jiménez-Melendo · Acta Mater · 2000 · 48 · 320110.1016/S1359-6454(00)00113-0 ↗
14. Schaller · J. Eur. Ceram. Soc · 2002 · 22 · 246110.1016/S0955-2219(02)00104-8 ↗
15. J. Dorn, in: Proceedings of the N.P.L. Symposium on Creep and Fracture of Metals at High Temperature, 1954, HMSO, London, 1956, pp. 89–132.
16. Daraktchiev · Phys. Stat. Sol. (a) · 2003 · 195 · 29310.1002/pssa.200305946 ↗