Production, microstructural and mechanical characterization of spray formed Al–6 wt.% Fe alloy and pre-mixed Al–6 wt.% Fe/SiCp composite
Source abstract
Abstract
Abstract Different batches of Al–6 wt.% Fe and of pre-composite Al–6 wt.% Fe/SiC powders were produced, via melting of aluminum followed by iron addition in the induction furnace of a gas atomizing unit, eventually adding in situ a suitable amount of SiC particulate. The inclusion of the reinforcing particles in the melt was enhanced by means of stirring under an argon shielding atmosphere. Gas atomization via sonic close-coupled discrete jet nozzles was thereafter performed, and a part of the spray cone was intercepted by a still substrate. The microstructural characterization of both the pre-composite powder and of the spray deposited samples was carried out by microscopy, image analysis and X-ray diffraction. The high viscosity of the matrix allowed to achieve a maximum volumetric fraction of reinforcement of around 10%. By means of X-ray stress analysis the residual stresses in the spray formed specimens were determined, and resulted to be compressive, and higher in the composite material. The elastic properties of the spray formed samples were determined by the flexural resonance test, carried out on prismatic samples cut from the spray formed samples, while their transverse strengths were determined by three points bend test.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Aluminum Alloys Composites Properties · Advanced ceramic materials synthesis · Advanced materials and composites
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (7)
Show source-provided references
1. Park · Mater. Des · 1966 · 17 · 255
2. Q. Xu, E.J. Lavernia, in: Proceedings of the SDMA 2000 Conference, Bremen, Germany, 26–28 June 2000, 17–36.
3. A. Banik, X. Pierrot, in: Proceedings of the SDMA 2000 Conference, Bremen, Germany, 26–28 June 2000, 171–180.
4. J.-M. Lee, S.-B. Kang, T. Sato, H. Tezuka, A. Kamio, Mater. Lett., 57, December 2002, 812–817.10.1016/S0167-577X(02)00878-9 ↗
5. S. Ho, E.J. Lavernia, Thermal residual stresses in functionally graded and layered 6061 Al/SiC materials, Metall. Mater. Trans. A 27A (1996) 3241–3249.10.1007/BF02663874 ↗
6. A. Zambon, B. Badan, in: A.B. Pandey, K.L. Kendig, T.J. Watson (Eds.), Proceedings of the Affordable Metal Matrix Composites for High Performance Applications—Session IV: Processing of Metal–Matrix Composites II, TMS (The Minerals, Metas & Materials Society), 2001, 223–231.
7. S. Spinner, W.E. Tefft, A method for determining mechanical resonance frequencies and for calculating elastic moduli from these frequencies, ASTM Proc., 61 (1961).