An analysis of the effect of hydrostatic pressure on the tensile deformation of aluminum-matrix composites
Source abstract
Abstract
Abstract The effect of superposed hydrostatic pressure on the tensile deformation of particle-reinforced Al-matrix composites was analyzed using a self-consistent approximation. The composite was represented in terms of an interpenetrating network of randomly distributed spheres, which stand for the intact and damaged regions in the composite. Each sphere contained an intact or broken ceramic particle at the center, and the model assumed that the fraction of damaged spheres increased during deformation. The load partitioning between intact and damaged regions in the composite as well as the stress redistribution due to damage was computed through a self-consistent scheme. It was shown that the tensile stresses in the ceramic particles, and thus the fraction of broken particles, were reduced as the hydrostatic pressure increased. This led to a moderate improvement in the composite flow stress but more significant gains were achieved in the strain at the onset of plastic instability. Both magnitudes increased with the hydrostatic pressure until a saturation stress was reached. Particle fracture was completely inhibited at this point, and higher pressures did not have any influence on the composite behavior, which was equivalent to that of the undamaged phase in the absence of hydrostatic pressure. Using reasonable values for the matrix and reinforcement properties, the model predictions for the composite strength and strain at the onset of plastic instability were in good agreement with the experimental data in the literature for high strength Al alloys reinforced with SiC and Al 2 O 3 particles.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Aluminum Alloys Composites Properties · Advanced ceramic materials synthesis · Microstructure and mechanical properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (28)
Show source-provided references
1. Lloyd · Int. Mater. Rev. · 1994 · 39 · 110.1179/imr.1994.39.1.1 ↗
2. Llorca · Mater. Sci. Eng. · 1994 · A185 · 2510.1016/0921-5093(94)90924-5 ↗
3. Llorca · 2000 · 3 · 91
4. Vasudevan · Mater. Sci. Eng. · 1989 · A107 · 6310.1016/0921-5093(89)90375-4 ↗
5. Liu · Metall. Trans. · 1989 · 20A · 240910.1007/BF02666676 ↗
6. Liu · Metall. Trans. · 1993 · 24A · 60910.1007/BF02656630 ↗
7. Vaidya · 1995 · 147
8. Lewandowski · Int. Mater. Rev. · 1998 · 43 · 14510.1179/imr.1998.43.4.145 ↗
9. Brockenbrough · Acta Metall. Mater. · 1995 · 43 · 1110.1016/0956-7151(94)00236-B ↗
10. González · Scri. Mater. · 1996 · 35 · 9110.1016/1359-6462(96)00100-5 ↗
11. Kiser · Acta Metall. Mater. · 1996 · 44 · 346510.1016/1359-6454(96)00028-6 ↗
12. Poza · Metall. Mater. Trans. · 1999 · 30A · 869
13. Christman · 1991 · 309
14. González · J. Mech. Phys. Solids · 2000 · 48 · 67510.1016/S0022-5096(99)00057-5 ↗
15. Hill · J. Mech. Phys. Solids · 1965 · 13 · 8910.1016/0022-5096(65)90023-2 ↗
16. Hutchinson · Proc. R. Soc. London · 1970 · A355 · 101
17. Berveiller · J. Mech. Phys. Solids · 1979 · 26 · 32510.1016/0022-5096(78)90003-0 ↗
18. Gilormini · C. R. Acad. Sci. Paris IIb · 1995 · 320 · 115
19. Ponte Castañeda · Adv. Appl. Mech. · 1998 · 34 · 17110.1016/S0065-2156(08)70321-1 ↗
20. Bao · Acta Metall. Mater. · 1991 · 39 · 187110.1016/0956-7151(91)90156-U ↗
21. Martı́nez · 1996 · 371
22. Llorca · J. Mech. Phys. Solids · 1998 · 46 · 110.1016/S0022-5096(97)00038-0 ↗
23. Llorca · Acta Metall. Mater. · 1995 · 43 · 18110.1016/0956-7151(95)90273-2 ↗
24. Lewis · Acta Metall. Mater. · 1995 · 43 · 368510.1016/0956-7151(95)90152-3 ↗
25. Wilkinson · Mater. Sci. Eng. · 1997 · A233 · 14510.1016/S0921-5093(97)00059-2 ↗
26. Lewandowski · Scri. Metall. · 1991 · 25 · 2110.1016/0956-716X(91)90347-4 ↗
27. Mahon · Acta Metall. Mater. · 1990 · 38 · 150310.1016/0956-7151(90)90118-Z ↗
28. Llorca · Acta Metall. Mater. · 1991 · 39 · 231710.1016/0956-7151(91)90014-R ↗