journal article·2015-07

Influence of dendritic solute segregation on tensile properties of Al–4 mass% Cu alloy castings consisting of single columnar crystal

Hiroshi Kato

Publisher page

Abstract

Abstract Al–4 mass% Cu alloy ingots consisting of single columnar crystal were prepared and subjected to tensile testing. Tensile properties, such as the 0.2% offset proof stress, tensile strength and elongation, were obtained in directions parallel and perpendicular to the growth direction of the columnar crystal. The tensile properties in the growth direction of the as-cast specimen decreased with increasing primary arm spacing λ p , but after solution heat treatment, they became independent of λ p . On the other hand, tensile properties perpendicular to the growth direction decreased with increasing λ p before and after heat treatment. From these results, it was concluded that the tensile properties in the growth direction were controlled by solute segregation, but those perpendicular to the growth direction were largely influenced by casting defects, such as cavities. The as-cast yield strength σ y in the growth direction was analyzed based on a continuously distributed dislocation model considering solute distribution in the primary arm, and the relationship σ y =σ const + kG 1/8 λ p −1/4 was obtained, where σ const and k are constants, and G is the temperature gradient around the dendrite tip. The calculated yield strength was compared with the 0.2% offset proof stress σ 0.2 of the as-cast specimen. Also, the yield strength perpendicular to the growth direction was analyzed based on fracture mechanics, and the relationship σ y = K y ( πl T /2) −1/2 was obtained, where K y is the stress intensity factor at yielding, and l T is the length of the cavity perpendicular to both the growth and the tensile directions and is related to λ p . The calculated yield strength was compared with σ 0.2 of the as-cast and the heat treated specimens. The estimated value of K y was comparable with the fracture toughness K IC reported in previous work.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Microstructure and mechanical properties · Aluminum Alloys Composites Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (36)

Show source-provided references
1. Yoon · Keikinzoku · 1979 · 29 · 159
2. Hall · Proc. Phys. Soc. B · 1951 · 64 · 74710.1088/0370-1301/64/9/303 ↗
3. Petch · J. Iron Steel Inst. · 1953 · 174 · 25
4. Kumai · Keikinzoku · 1994 · 44 · 222
5. Kanazawa · Trans. JSME: Ser. A · 1998 · 64 · 195610.1299/kikaia.64.1956 ↗
6. Quaresma · Metall. Mater. Trans. A · 2000 · 31A · 316710.1007/s11661-000-0096-0 ↗
7. Osóri · Mater. Sci. Eng. A · 2002 · 325 · 10310.1016/S0921-5093(01)01455-1 ↗
8. Goulart · Mater. Sci. Eng. A · 2006 · 421 · 24510.1016/j.msea.2006.01.050 ↗
9. Osório · Metall. Mater. Trans. A · 2006 · 37A · 252510.1007/BF02586225 ↗
10. Cruz · Metall. Mater. Trans. A · 2010 · 41A · 97210.1007/s11661-009-0161-2 ↗
11. Ferri · Mater. Sci. Eng. A · 2010 · 527 · 462410.1016/j.msea.2010.03.041 ↗
12. Osório · Int. J. Electrochem. Sci. · 2011 · 6 · 627510.1016/S1452-3981(23)19680-5 ↗
13. Odanović · Acta Phys. Pol. A · 2012 · 121 · 11110.12693/APhysPolA.121.111 ↗
14. Li · J. Less Common Met. · 1985 · 110 · 17110.1016/0022-5088(85)90318-2 ↗
15. Spinelli · Int. J. Therm. Sci. · 2012 · 51 · 14510.1016/j.ijthermalsci.2011.08.014 ↗
16. Merlin · Metall. Sci. Technol. · 2009 · 27 · 21
17. Çadirli · J. Electron. Mater. · 2011 · 40 · 190310.1007/s11664-011-1668-z ↗
18. Wang · Metall. Mater. Trans. A · 2003 · 34A · 288710.1007/s11661-003-0189-7 ↗
19. Yamashita · Keikinzoku · 1997 · 47 · 98
20. Campbell · 2011
21. Kato · J. Soc. Mater. Sci. Jpn. · 1989 · 38 · 38410.2472/jsms.38.384 ↗
22. Pollock · J. Propuls. Power · 2006 · 22 · 36110.2514/1.18239 ↗
23. H. Kato, M. Matsuo, M. Hoshino, K. Yoshikawa. In: Proceedings of the International Conference on Experimental Mechanics, Chinese Society of Theoretical and Applied Mechanics and Japanese Society, NDI, Beijing, China, 1985, pp. 432−437.
24. Kato · J. Soc. Mater. Sci. Jpn. · 1989 · 38 · 25510.2472/jsms.38.255 ↗
25. Leibfried · Z. Phys. · 1951 · 130 · 21410.1007/BF01337695 ↗
26. Sekhar · Acta Mater. · 2002 · 50 · 484110.1016/S1359-6454(02)00352-X ↗
27. Teng · Acta Mater. · 2009 · 57 · 349710.1016/j.actamat.2009.04.005 ↗
28. Burden · J. Cryst. Growth · 1974 · 22 · 10910.1016/0022-0248(74)90127-4 ↗
29. Koss · Metall. Mater. Trans. A · 1999 · 30A · 317710.1007/s11661-999-0228-0 ↗
30. Okamoto · J. Cryst. Growth · 1975 · 29 · 13710.1016/0022-0248(75)90217-1 ↗
31. Young · Metall. Trans. A · 1975 · 6A · 19710.1007/BF02673688 ↗
32. Callister · 2011 · 214
33. Tiryakiogˇlu · Mater. Eng. Sci. A · 2009 · 506 · 2310.1016/j.msea.2008.10.044 ↗
34. Sagawa · Imono · 1989 · 61 · 252
35. Kumai · Mater. Trans. · 2004 · 45 · 170610.2320/matertrans.45.1706 ↗
36. Tiryakiogˇlu · Mater. Sci. Eng. A · 2008 · 497 · 51210.1016/j.msea.2008.06.037 ↗