Compound role of tension twins and compression twins in microstructure and mechanical properties of Mg-Sn-Li rod
Source abstract
Abstract
Abstract This work explores the compound effect of tension twins and compression twins on extruded Mg-5Sn-0.3Li, with an emphasis laid on the microstructure and mechanical properties. To induce both tension twins and compression twins, Mg-5Sn-0.3Li in the cast condition was chosen and subjected to 5% pre-compression. Both the pre-strained sample and unstrained sample were then exposed to extrusion. Our results reveal that pre-strained Mg-5Sn-0.3Li rods exhibit higher overall mechanical properties including yield strength, ultimate strength and elongation to failure in the extrusion condition. The relevant mechanisms were discussed.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties · Metal and Thin Film Mechanics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (42)
Show source-provided references
1. Twinning and the ductility of magnesium alloys10.1016/j.msea.2007.02.109 ↗
2. Deformation mechanisms and dynamic recrystallization of AZ31 Mg alloy with different initial textures during hot tension10.1016/j.matdes.2013.03.028 ↗
3. The effect of twin-twin interactions on the nucleation and propagation of twinning in magnesium10.1016/j.actamat.2013.02.030 ↗
4. Role of {10-12} twinning characteristics in the deformation behavior of a polycrystalline magnesium alloy10.1016/j.actamat.2010.07.002 ↗
5. Temperature dependency of slip and twinning in plane strain compressed magnesium single crystals10.1016/j.actamat.2010.11.064 ↗
6. The interrupted properties of an extruded Mg alloy10.1016/j.matdes.2012.08.074 ↗
7. Effect of aging precipitation on mechanical anisotropy of an extruded Mg-Y-Nd alloy10.1016/j.matdes.2011.08.043 ↗
8. EBSD analysis of deformation modes in Mg-3Al-1Zn10.1016/j.scriptamat.2006.07.036 ↗
9. Reorientation and stress relaxation due to twinning: modeling and experimental characterization for Mg10.1016/j.actamat.2008.01.057 ↗
10. Twinning-induced softening in polycrystalline AM30 Mg alloy at moderate temperatures10.1016/j.scriptamat.2005.11.029 ↗
11. Dynamic recrystallization of the H- and O-tempered Mg AZ31 sheets at elevated temperatures10.1016/j.msea.2012.02.042 ↗
12. Enhancing stretch formability of rolled Mg sheets by pre-inducing contraction twins and recrystallization annealing10.1016/j.msea.2015.01.027 ↗
13. Softening and dynamic recrystallization in magnesium single crystals during c-axis compression10.1016/j.actamat.2011.10.013 ↗
14. Effect of initial texture on dynamic recrystallization of AZ31 Mg alloy during hot rolling10.1016/j.msea.2010.11.069 ↗
15. Orientational analysis of static recrystallization at compression twins in a magnesium alloy AZ3110.1016/j.msea.2009.03.045 ↗
16. Analysis of the static recrystallization at tension twins in AZ31 magnesium alloy10.3724/SP.J.1037.2009.00533 ↗
17. Annealing hardening in detwinning deformation of Mg-3Al-1Zn alloy10.1016/j.msea.2013.11.080 ↗
18. Periodic segregation of solute atoms in fully coherent twin boundaries10.1126/science.1229369 ↗
19. Detwinning behavior of Mg-3Al-1Zn alloy at elevated temperatures10.1016/j.msea.2014.08.034 ↗
20. Influence of deformation twinning on static annealing of AZ31 Mg alloy10.1016/j.actamat.2013.06.037 ↗
21. Effect of Li on microstructure, mechanical properties and fracture mechanism of as-cast Mg-5Sn alloy10.1016/j.msea.2015.06.063 ↗
22. The beneficial effect of AgIn addition on deformation behavior, microstructure and texture in Mg-Al-Zn alloy during single pass warm rolling10.1016/j.matdes.2015.05.029 ↗
23. Ductility improvement by twinning and twin-slip interaction in a Mg-Y alloy10.1016/j.matdes.2013.12.014 ↗
24. A high-strength Mg-Sn-Zn-Al alloy extruded at low temperature10.1016/j.scriptamat.2008.07.042 ↗
25. The influence of a secondary twin on the detwinning deformation of a primary twin in Mg-3Al-1Zn alloy10.1016/j.msea.2014.03.068 ↗
26. Role of volume fraction of second phase particles, dislocation-twin and twin-twin interactions in the reduced tension-compression yield asymmetry10.1016/j.matdes.2016.02.079 ↗
27. Hall-Petch relation for deformation twinning in solid solution magnesium alloys10.1016/j.msea.2012.10.040 ↗
28. Influence of texture on Hall-Petch relationships in an Mg alloy10.1016/j.actamat.2014.08.023 ↗
29. Cold rolling textures in AZ31 wrought magnesium alloy10.1016/j.scriptamat.2004.01.010 ↗
30. Hardening evolution of AZ31B Mg sheet10.1016/j.ijplas.2006.03.005 ↗
31. Modeling the effect of twinning and detwinning during strain-path changes of magnesium alloy AZ3110.1016/j.ijplas.2008.05.005 ↗
32. Flow softening, twinning and dynamic recrystallization in AZ31 magnesium10.1016/j.msea.2013.06.074 ↗
33. Effect of the Zn content on the microstructure and mechanical properties of indirect-extruded Mg-5Sn-xZn alloys10.1016/j.matdes.2011.02.012 ↗
34. Micro-alloying Mg with Y, Ce, Gd and La for texture modification-a comparative study10.1016/j.msea.2009.12.036 ↗
35. On the influence of the grain size and solute content on the AE response of magnesium alloys tested in tension and compression10.1016/j.msea.2006.02.470 ↗
36. The deformation, recrystallisation and texture of three magnesium alloy extrusions10.1179/174328407X226509 ↗
37. Heat-treatable Mg-Sn-Zn wrought alloy10.1016/j.scriptamat.2009.03.014 ↗
38. Fundamental studies on the thermal stability and mechanical characteristics of AZ31 alloy10.1016/j.msea.2011.12.054 ↗
39. Effects of thermal treatment on microstructure and mechanical properties of a Mg-Gd-based alloy plate10.1016/j.msea.2016.02.032 ↗
40. Effect of precipitate shape and habit on mechanical asymmetry in magnesium alloys10.1007/s11661-012-1466-0 ↗
41. Bettles · 2012
42. Effect of cold pre-forging on the microstructure and mechanical properties of extruded Mg-8Sn-1Al-1Zn alloy10.1016/j.msea.2014.06.053 ↗