journal article·2019-02

Age hardening response of AA7108A investigated by means of Synchrotron-based X-ray Absorption Spectroscopy (XAS) measurements

Chijioke Kenneth Akuata, Christoph Altenbach, Christian Schnatterer, Piyada Suwanpinij, Chatree Saiyasombat, Daniela Zander

Publisher page

Abstract

Abstract Enhanced strengthening achieved during age hardening of 7xxx alloys, necessitated the need to study the age hardening response of Cu-free AA7108A wire, as a potential material for automobile fastener production. Age hardening response was investigated by means of Synchrotron-based X-ray Absorption Spectroscopy (XAS) measurements. Linear combination fitting (LCF), using XANES spectra of Zn K-edge showed the gradual removal of Zn atoms from the aluminum matrix of the T4 condition (where Zn is in solution and in GP zones), when subjected to one-step artificial aging treatment at 130 °C and 200 °C, respectively. The reduction of matrix Zn during aging at 130 °C is mainly due to the precipitation of the semi-coherent η’ phase, whose number density increased with increasing aging time. η’ phase is the major phase responsible for hardness and electrical conductivity increase during aging at 130 °C. Reduction of matrix Zn concentration during aging at 200 °C is due to the formation and coarsening of the incoherent η-MgZn2 phase. This resulted in a dramatic decrease in hardness and an increasing trend in the electrical conductivity during aging at 200 °C. Calorimetric study revealed that natural aging occurred at room temperature after solution treatment, and GP zone solvus is found to be below 130 °C. In addition, precipitation of the η’ phase at 130 °C is retarded, due to reduced concentration of vacancies, attributed to the presence of Zirconium (Zr) in the alloy.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloy Microstructure Properties · Aluminum Alloys Composites Properties · Microstructure and mechanical properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (45)

Show source-provided references
1. Microstructure and corrosion behaviour of low copper 7xxx aluminium alloy10.1002/sia.5226 ↗
2. Influence of zirconium and copper on the early stages of aging in Al-Zn-Mg alloys10.1007/s11661-001-0117-7 ↗
3. Pure 7000 alloys: microstructure, heat treatments and hot working
4. Precipitates, zones and transitions during aging of Al-Zn-Mg-Zr7000 series alloy10.1179/026708304225010424 ↗
5. Revisiting the precipitation sequence in Al–Zn–Mg-based alloys by high-resolution transmission electron microscopy10.1016/j.scriptamat.2010.08.001 ↗
6. Differential scanning calorimetry and electron diffraction investigation on low-temperature aging in Al-Zn-Mg alloys10.1007/s11661-000-0269-x ↗
7. Effect of predeformation and preaging at room temperature in Al–Zn–Mg–(Cu,Zr) alloys10.1016/S0921-5093(00)01883-9 ↗
8. Crystal structure and stability of complex precipitate phases in Al–Cu–Mg–(Si) and Al–Zn–Mg alloys10.1016/S1359-6454(01)00229-4 ↗
9. GP-zones in Al–Zn–Mg alloys and their role in artificial aging10.1016/S1359-6454(01)00251-8 ↗
10. Early-stage precipitation in Al–Zn–Mg–Cu alloy (7050)10.1016/j.actamat.2004.06.025 ↗
11. Chapter 2 - Physical metallurgy of 7XXX alloys
12. Effects of microstructure on the mechanical properties and stress corrosion cracking of an Al-Zn-Mg-Sc-Zr alloy by various temper treatments10.2320/matertrans.48.600 ↗
13. An electron microscope investigation of the microstructure in an aluminium-zinc-magnesium alloy10.1016/0001-6160(70)90016-7 ↗
14. Cousland, structure of the metastable eta prime phase in aluminum-zinc- magnesium alloys
15. HREM study and structure modeling of the η′ phase, the hardening precipitates in commercial Al–Zn–Mg alloys10.1016/S1359-6454(99)00138-X ↗
16. 12 - Precipitation and solute clustering in aluminum: advanced characterisation techniques
17. Characterisation of the composition and volume fraction of η′ and η precipitates in an Al–Zn–Mg alloy by a combination of atom probe, small-angle X-ray scattering and transmission electron microscopy10.1016/j.actamat.2005.03.004 ↗
18. Effect of Cu content on corrosion behavior of 7xxx series aluminum alloys10.1149/1.1695385 ↗
19. Effect of Zn content on the microstructure and properties of super-high strength Al-Zn-Mg-Cu alloys10.1007/s11661-013-1731-x ↗
20. Effect of three-stage homogenization on mechanical properties and stress corrosion cracking of Al-Zn-Mg-Zr alloys10.1016/j.msea.2016.08.071 ↗
21. The influence of zirconium on the early stages of aging of a ternary Al–Zn–Mg alloy10.1016/0956-7151(94)90406-5 ↗
22. Effects of Sc and Zr microalloying additions on the microstructure and mechanical properties of new Al–Zn–Mg alloys10.1016/j.jallcom.2012.03.108 ↗
23. Copper precipitation in FeCu, FeCuMn, and FeCuNi dilute alloys followed by X-ray absorption spectroscopy
24. Quantification of vanadium precipitates in HSLA steel by synchrotron X-ray absorption spectroscopy (XAS)10.3139/120.110802 ↗
25. Experimental investigation on the formation of Cr-containing dispersoids in an AlSi3 alloy by X-ray synchrotron radiation10.1016/j.jallcom.2018.01.337 ↗
26. Alloying aluminum alloys with scandium and zirconium additives10.1007/BF01395323 ↗
27. ATHENA, ARTEMIS, HEPHAESTUS: data analysis for X‐ray absorption spectroscopy using IFEFFIT10.1107/S0909049505012719 ↗
28. Effect of heat treatment on plasticity of Al–Zn–Mg alloy: microstructure evolution and mechanical properties10.1016/j.phpro.2009.11.079 ↗
29. Non-destructive investigation on the effect of precipitation hardening on impact toughness of 7020 Al–Zn–Mg alloy10.1016/j.msea.2004.05.001 ↗
30. The HighScore suite10.1017/S0885715614000840 ↗
31. Effects of pre-treatments on aging precipitates and corrosion resistance of a creep-aged Al–Zn–Mg–Cu alloy10.1016/j.matdes.2015.06.029 ↗
32. Investigation of precipitation behavior and related hardening in AA 7055 aluminum alloy10.1016/j.msea.2008.09.065 ↗
33. Mechanical properties, corrosion behavior and microstructures of a non-isothermal ageing treated Al-Zn-Mg-Cu alloy10.1016/j.msea.2017.01.086 ↗
34. Precipitation behavior and properties of a new high strength Al-Zn-Mg-Cu alloy10.1016/S1003-6326(11)61511-2 ↗
35. Effect of Cu content and aging conditions on pitting corrosion damage of 7xxx series aluminum alloys10.1149/2.0301504jes ↗
36. Correlation of strength with hardness and electrical conductivity for aluminium alloy 701010.4028/www.scientific.net/MSF.519-521.853 ↗
37. Structure–property correlations in Al 7050 and Al 7055 high-strength aluminum alloys10.1016/j.msea.2007.05.116 ↗
38. 22 - Strengthening mechanisms in aluminum alloys10.1016/B978-0-12-341831-9.50027-9 ↗
39. Aluminium alloys-A century of age hardening
40. 10 - Aging behavior and microstructure evolution in the processing of aluminum alloys
41. Microstructure evolution and deformation behavior of ultrafine-grained Al–Zn–Mg alloys with fine η′ precipitates10.1016/j.actamat.2010.08.034 ↗
42. Effect of aging time to the commercial aluminum alloy modified with zirconium addition10.4028/www.scientific.net/MSF.819.50 ↗
43. Determination of kinetic parameters from calorimetric study of solid state reactions in 7150 Al-Zn-Mg alloy10.1016/S1003-6326(11)60843-1 ↗
44. A calorimetric study of aluminium alloy AA-707510.1007/BF00540811 ↗
45. Investigation of mechanical and corrosion properties of an Al–Zn–Mg–Cu alloy under various ageing conditions and interface analysis of η′ precipitate10.1016/j.matdes.2015.06.183 ↗