journal article·2007-04

Microstructural characterization of dispersion-strengthened Cu–Ti–Al alloys obtained by reaction milling

Rodrigo A. Espinoza, Rodrigo H. Palma, Aquiles O. Sepúlveda, Víctor Fuenzalida, Guillermo Solórzano, Aldo Craievich, David J. Smith, Takeshi Fujita, Marta López

Publisher page

Abstract

Abstract The microstructure, electrical conductivity and hot softening resistance of two alloys (G-10 and H-20), projected to attain Cu–2.5 vol.% TiC–2.5 vol.% Al 2 O 3 nominal composition, and prepared by reaction milling and hot extrusion, were studied. The alloys were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and several chemical analysis techniques. The first alloy, G-10, showed the formation of Al 2 O 3 nanodispersoids and the presence of particles from non-reacted raw materials (graphite, Ti and Al). A second alloy, H-20, was prepared employing different fabrication conditions. This alloy exhibited a homogeneous distribution of Al 2 O 3 and Ti–Al–Fe nanoparticles, with the microstructure being stable after annealing and hot compression tests. These nanoparticles acted as effective pinning sites for dislocation slip and grain growth. The room-temperature hardness of the H-20 consolidated material (330 HV) was approximately maintained after annealing for 1 h at 1173 K; the electrical conductivity was 60% IACS (International Annealing Copper Standard).
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloys Composites Properties · Microstructure and mechanical properties · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (10)

Show source-provided references
1. Groza · Mater. Sci. Eng. A · 1993 · 171 · 11510.1016/0921-5093(93)90398-X ↗
2. Anzel · Z. Metalkd. · 1999 · 90 · 621
3. L. Lü, M.O. Lai, Mechanical Alloying, Kluwer Academics Publishers, Massachusetts, EEUU, 1998.10.1007/978-1-4615-5509-4 ↗
4. Sauer · Z. Metallkd. · 1998 · 89 · 119
5. R. Palma, A. Sepúlveda, A. Zúñiga, R. Pérez., Molienda reactiva de aleaciones Cu–Ti–C, Anales de las Jornadas SAM-CONAMET-AAS 2001, Posadas, Argentina, Septiembre (2001) 317–324.
6. Palma · Mater. Sci. Forum · 2003 · 416–418 · 16210.4028/www.scientific.net/MSF.416-418.162 ↗
7. Palma · Mater. Sci. Eng. A · 2004 · 384 · 26210.1016/S0921-5093(04)00862-7 ↗
8. Kaneko · 1998 · 323
9. Huang · Acta Mater. · 2006 · 54 · 65510.1016/j.actamat.2005.10.002 ↗
10. GlidCop technical data sheet: http://www.spotweldingconsultants.com/glidcop.htm.