journal article·2002-01

Factors contributing to creep strengthening in discontinuously-reinforced materials

Bing Q. Han, Terence G. Langdon

Materials Science and Engineering: A· Volume 322· Issue 1-2
Publisher page

Abstract

Abstract There have been several experimental investigations of the creep behavior of materials with discontinuous reinforcement. For these materials, logarithmic plots of the steady-state or minimum strain rate against the applied stress usually reveal significant curvature such that the stress exponent, determined from the slope of the line, increases with decreasing stress. Plots of this nature are usually interpreted by invoking a threshold stress, σo and replacing the applied stress, σ, with an effective stress, defined as (σ−σo). This paper examines the implications of this approach using published creep data for several aluminum-based materials. It is shown that the introduction of an effective stress leads to a stress exponent that is similar to that observed in the unreinforced matrix material but, nevertheless, the creep rates in the reinforced materials are often significantly slower than in the matrix. This difference is examined with reference to the occurrence of load transfer and substructure strengthening.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Aluminum Alloys Composites Properties · Advanced ceramic materials synthesis · Structural Behavior of Reinforced Concrete

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (34)

Show source-provided references
1. Yavari · Acta Metall. · 1981 · 29 · 149510.1016/0001-6160(81)90184-X ↗
2. Yavari · Acta Metall. · 1982 · 30 · 2182
3. Sherby · Prog. Mater. Sci. · 1967 · 13 · 325
4. Langdon · Mater. Sci. Eng. · 2000 · A283 · 26610.1016/S0921-5093(00)00624-9 ↗
5. Gibeling · Mater. Sci. Eng. · 1980 · 45 · 12310.1016/0025-5416(80)90218-9 ↗
6. Kelly · Proc. R. Soc. Lond. · 1972 · 328A · 26710.1098/rspa.1972.0077 ↗
7. Kelly · Proc. R. Soc. Lond. · 1972 · 328A · 28310.1098/rspa.1972.0078 ↗
8. Nardone · Scr. Metall. · 1986 · 20 · 4310.1016/0036-9748(86)90210-3 ↗
9. Li · Acta Mater. · 1999 · 47 · 339510.1016/S1359-6454(99)00219-0 ↗
10. Čadek · Mater. Sci. Eng. · 1995 · A190 · 910.1016/0921-5093(94)09605-V ↗
11. Lagneborg · Metal. Sci. · 1976 · 10 · 2010.1179/030634576790431462 ↗
12. Dobeš · Scr. Mater. · 1998 · 38 · 179710.1016/S1359-6462(98)00104-3 ↗
13. Bird · 1969 · 255
14. Park · Acta Metall. Mater. · 1990 · 38 · 214910.1016/0956-7151(90)90082-R ↗
15. Park · Acta Metall. Mater. · 1994 · 42 · 66710.1016/0956-7151(94)90264-X ↗
16. Li · Metall. Mater. Trans. · 1998 · 29A · 252310.1007/s11661-998-0224-9 ↗
17. Čadek · Mater. Sci. Eng. · 1998 · A248 · 6510.1016/S0921-5093(98)00518-8 ↗
18. Čadek · Mater. Sci. Eng. · 1998 · A252 · 110.1016/S0921-5093(98)00672-8 ↗
19. Li · Scr. Mater. · 1997 · 36 · 145710.1016/S1359-6462(97)00041-9 ↗
20. Čadek · Scr. Mater. · 1999 · 40 · 126910.1016/S1359-6462(99)00064-0 ↗
21. Mohamed · Mater. Sci. Eng. · 1992 · A150 · 2110.1016/0921-5093(90)90004-M ↗
22. Li · Metall. Mater. Trans. · 1999 · 30A · 31510.1007/s11661-999-0320-5 ↗
23. Friedel · 1964
24. Mohamed · Metall. Trans. · 1974 · 5 · 233910.1007/BF02644014 ↗
25. Li · Acta Mater. · 1998 · 46 · 114310.1016/S1359-6454(97)00320-0 ↗
26. Pichler · Acta Mater. · 1996 · 44 · 275110.1016/1359-6454(95)00383-5 ↗
27. Dunand · Acta Mater. · 1997 · 45 · 456910.1016/S1359-6454(97)00135-3 ↗
28. Park · Metall. Mater. Trans. · 1995 · 26A · 311910.1007/BF02669441 ↗
29. Li · J. Mater. Sci. Lett. · 1996 · 15 · 61610.1007/BF00579268 ↗
30. Shi · Metall. Mater. Trans. · 1997 · 28A · 274110.1007/s11661-997-0031-8 ↗
31. Krajewski · 2000 · 207
32. Bao · Acta Metall. · 1991 · 39 · 187110.1016/0956-7151(91)90156-U ↗
33. Ravichandran · Acta Metall. · 1993 · 41 · 335110.1016/0956-7151(93)90216-F ↗
34. Li · Mater. Sci. Eng. · 1998 · A245 · 110.1016/S0921-5093(97)00712-0 ↗