Hot-pressed ZrB2–SiC–YSZ composites with various yttria content: Microstructure and mechanical properties
Source abstract
Abstract
Abstract ZrB 2 –10 vol%SiC–20 vol%YSZ composites were prepared by hot-pressed sintering with yttria content ranging from 2 mol% to 8 mol% in YSZ. The phase constitution, microstructure and mechanical properties of the composites were found to be strongly dependent on the yttria content. The average grain size became bigger for the composites with higher yttria content. When the yttria content was below 3 mol%, there is no cubic zirconia in the polished surface of composites, and the flexural strength of the composites was above 740 MPa. With the increase in yttria content, the fracture toughness fell down from 6.4 MPa m 1/2 to 5.6 MPa m 1/2 . Vickers’ hardness of the hot-pressed composites varied above 18 GPa without obvious effect of the yttria content.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advanced ceramic materials synthesis · Advanced materials and composites · MXene and MAX Phase Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (28)
Show source-provided references
1. Fahrenholtz · J. Am. Ceram. Soc. · 2007 · 90 · 134710.1111/j.1551-2916.2007.01583.x ↗
2. Upadhya · Am. Ceram. Soc. Bull. · 1997 · 76 · 51
3. Sung · J. Appl. Phys. · 2002 · 91 · 390410.1063/1.1436296 ↗
4. Opeka · J. Eur. Ceram. Soc. · 1999 · 19 · 240510.1016/S0955-2219(99)00129-6 ↗
5. Van Wie · J. Mater. Sci. · 2004 · 39 · 591510.1023/B:JMSC.0000041688.68135.8b ↗
6. Jackson · J. Mater. Sci. · 2004 · 39 · 590510.1023/B:JMSC.0000041687.37448.06 ↗
7. Meerson · Inorg. Mater. · 1968 · 4 · 267
8. Kalish · J. Am. Ceram. Soc. · 1969 · 52 · 2610.1111/j.1151-2916.1969.tb12654.x ↗
9. Kalish · J. Am. Ceram. Soc. · 1969 · 52 · 31
10. Rezaie · J. Mater. Sci. · 2007 · 42 · 273510.1007/s10853-006-1274-2 ↗
11. Monteverde · Mater. Sci. Eng. A · 2003 · 346 · 31010.1016/S0921-5093(02)00520-8 ↗
12. Monteverde · Adv. Eng. Mater. · 2003 · 5 · 50810.1002/adem.200300349 ↗
13. X.H. Zhang, W.J. Li, C.Q. Hong, W.B. Han, Int. J. Appl. Ceram. Technol. doi:10.1111/j.1744-7402.2008.02199.x.10.1111/j.1744-7402.2008.02199.x ↗
14. Zhang · Mater. Lett. · 2008 · 62 · 240410.1016/j.matlet.2007.12.006 ↗
15. Ghosh · Mater. Lett. · 2006 · 60 · 117010.1016/j.matlet.2005.10.102 ↗
16. Dell’Agli · J. Eur. Ceram. Soc. · 2000 · 20 · 13910.1016/S0955-2219(99)00151-X ↗
17. Bakshi · Composite A · 2006 · 37 · 212810.1016/j.compositesa.2005.11.012 ↗
18. Basu · J. Am. Ceram. Soc. · 2006 · 89 · 240510.1111/j.1551-2916.2006.01083.x ↗
19. Wada · Surf. Coat. Technol. · 2006 · 200 · 272510.1016/j.surfcoat.2005.02.121 ↗
20. Jadhav · Acta Mater. · 2006 · 54 · 334310.1016/j.actamat.2006.03.024 ↗
21. Guo · Acta Mater. · 2005 · 53 · 516110.1016/j.actamat.2005.07.033 ↗
22. Fullman · Trans. AIME · 1953 · 197 · 447
23. Huang · J. Eur. Ceram. Soc. · 2007 · 27 · 68910.1016/j.jeurceramsoc.2006.04.040 ↗
24. Hwang · Mater. Sci. Eng. A · 2007 · 464 · 21610.1016/j.msea.2007.03.002 ↗
25. Ye · Ceram. Int. · 1995 · 21 · 24310.1016/0272-8842(95)99789-E ↗
26. Armstrong · Metall. Trans. · 1970 · 65 · 116910.1007/BF02900227 ↗
27. Toraya · J. Am. Ceram. Soc. · 1984 · 67 · 11910.1111/j.1151-2916.1984.tb19614.x ↗
28. Faber · Acta Metall. · 1983 · 31 · 56510.1016/0001-6160(83)90046-9 ↗