journal article·2007-11

Inelastic deformation and its related life under cyclic/creep loadings in Si3N4-monolithic and Si3N4/SiCw-composite ceramics at elevated temperature

K. Hatanaka, Y. Ishiga, R. Kawazoe, M. Hasui, J. Ohgi, H. Ogawa

Publisher page

Abstract

Push-pull low cycle fatigue and creep tests were performed in monolithic-Si 3 N 4 and composite-Si 3 N 4 /SiCw materials at 1573 K. Then cyclic stress-strain response and creep strain were measured with a newly developed extensometer. The inelastic strain, which is greatly dependent upon stress/strain rate, was detected in both the materials. It was found from the shape of the cyclic stress-strain hysteresis loop that inelastic strain was easier to generate under tensile than under compressive loading; the width of the hysteresis loop is larger on the tensile stress side than on the compressive stress side. Such a characteristic cyclic stress-strain response is much more enhanced in the composite-Si 3 N 4 /SiCw than in the monolithic-Si 3 N 4 . The low cycle fatigue life plotted against inelastic strain range is much longer in the former than in the latter, although the difference is reduced with decreasing the controlled strain range. Moreover, greater creep resistance is attained in the former than in the latter at the lower stress level, while the opposite is the case at the higher stress level.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced ceramic materials synthesis · Advanced materials and composites · Aluminum Alloys Composites Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (19)

Show source-provided references
1. Luecke · J. Am. Ceram. Soc. · 1996 · 79 · 161710.1111/j.1151-2916.1996.tb08773.x ↗
2. Carroll · J. Am. Ceram. Soc. · 1989 · 72 · 161010.1111/j.1151-2916.1989.tb06291.x ↗
3. Hockey · J. Mater. Sci. · 1991 · 26 · 393110.1007/BF01184994 ↗
4. Krause · J. Am. Ceram. Soc. · 1999 · 82 · 123310.1111/j.1151-2916.1999.tb01901.x ↗
5. Widjaja · J. Am. Ceram. Soc. · 1999 · 82 · 65710.1111/j.1151-2916.1999.tb01814.x ↗
6. Zhu · J. Am. Ceram. Soc. · 1999 · 82 · 11710.1111/j.1151-2916.1999.tb01731.x ↗
7. Rendtel · J. Eur. Ceram. Soc. · 2002 · 22 · 251710.1016/S0955-2219(02)00112-7 ↗
8. Li · J. Am. Ceram. Soc. · 1999 · 82 · 149710.1111/j.1151-2916.1999.tb01947.x ↗
9. Hatanaka · 1996 · 515
10. Ferber · Ceram. Eng. Sci. Proc. · 1990 · 11 · 102810.1002/9780470313008.ch34 ↗
11. Evans · J. Am. Ceram. Soc. · 1990 · 73 · 18710.1111/j.1151-2916.1990.tb06493.x ↗
12. Elahi · Ceram. Eng. Sci. Proc. · 1995 · 16 · 7510.1002/9780470314715.ch7 ↗
13. Zhu · J. Am. Ceram. Soc. · 1998 · 81 · 226910.1111/j.1151-2916.1998.tb02621.x ↗
14. Lamouroux · J. Eur. Ceram. Soc. · 1994 · 14 · 52910.1016/0955-2219(94)90124-4 ↗
15. Evans · Acta Metall. Mater. · 1997 · 45 · 2310.1016/S1359-6454(96)00143-7 ↗
16. Holmes · J. Am. Ceram. Soc. · 1991 · 74 · 163910.1111/j.1151-2916.1991.tb07152.x ↗
17. Hatanaka · Trans. Jpn. Soc. Mech. Eng. · 2001 · 67-A · 39710.1299/kikaia.67.397 ↗
18. J.E. Dorn, Creep and Fracture of Metals at High Temperature, Proceedings of a Symposium held at the National Physical Laboratory, May 31–June 2, 1954, H.M. Stationery Office, London, U.K., 1956, pp. 89–138.
19. Pan · J. Am. Ceram. Soc. · 2005 · 88 · 191410.1111/j.1551-2916.2005.00425.x ↗