journal article·2019-10

Application of bending creep for examining effect of service conditions on creep response of steel

Faizan Hijazi, Jyotirmaya Kar, A.H.V. Pavan, Kulvir Singh, Praveen Kumar, Vikram Jayaram

Publisher page

Abstract

Abstract We demonstrate that creep testing of cantilevers in bending is suitable for evaluating steady-state creep parameters, including the stress exponent. In particular, a low alloy bainitic boiler tube steel, namely T11, in as-fabricated condition and after 27 years of service in a coal-fired power-plant were tested in bending at 600 °C at effective steady-state stresses of 100–200 MPa. Steady-state strain rates obtained from the bending tests matched reasonably well with those obtained from uniaxial compression tests performed at equivalent stresses, thereby unambiguously validating the bending test methodology for the entire range of stress. All types of samples showed a stress exponent of 6; however, the steady-state strain rates of the in-service samples were ~7 times larger than those of as-fabricated samples. Although this suggests a substantial loss in the creep resistance of the tubes at the end of the design-life, the “to-be-discarded” tube may still have considerable residual life. Microstructural evaluation of the samples revealed coarsening of carbides in bainite and metal enrichment of carbides, with excess of M6C, with exposure to the service conditions. A structure-property correlation is established to explain the experimental observations, and results are discussed in light of existing literature.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: High Temperature Alloys and Creep · Fire effects on concrete materials · Microstructure and Mechanical Properties of Steels

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (17)

Show source-provided references
1. Dieter · 1961
2. Courtney · 2000
3. Poirier · 1985
4. Nabarro · 1995
5. Creep of metallic materials in bending10.1007/s11837-019-03707-1 ↗
6. Experimental and analytical investigation of creep in bending
7. An investigation of the nature of creep under stresses produced by pure flexure
8. The utilization of creep test data in engineering design10.1243/PIME_PROC_1935_131_012_02 ↗
9. Bending of beams with creep10.1063/1.1698351 ↗
10. A numerical procedure for retrieving material creep properties from bending creep tests10.1016/j.actamat.2007.07.035 ↗
11. Calculation of stresses and strains in four-point bending creep tests10.1111/j.1151-2916.1971.tb12263.x ↗
12. A small cantilever beam test for determination of creep properties of materials10.1111/ffe.12225 ↗
13. Steady creep of a tube under combined bending and internal pressure10.1115/1.3662622 ↗
14. Marin · Creep Deflections in Columns · 1995 · 103
15. Standard specification for seamless ferritic and austenitic alloy- steel boiler, superheater, and heat-exchanger tubes, boiler and pressure vessel code IIA
16. Evolution of carbide precipitates in 2.25Cr- 1Mo steel during long-term service in a power plant10.1007/s11661-010-0194-6 ↗
17. Evolution and life assessment in power plants10.5772/26766 ↗