journal article·2003-06

Precipitation of Cu in Fe–Cu alloys by high-speed deformation

T. Ishizaki, T. Yoshiie, K. Sato, S. Yanagita, Q. Xu, M. Komatsu, M. Kiritani

Materials Science and Engineering: A· Volume 350· Issue 1-2
Publisher page

Abstract

Abstract The differences between defect structures in Fe–Cu alloys deformed at the high (4.3×10 5 s −1 ) and the low strain rate (67 s −1 ) were studied. Positron lifetime and coincidence Doppler broadening (CDB) measurements were carried out to investigate the formation of vacancy clusters and Cu precipitates. Both the size of vacancy clusters and the total amount of vacancy-type defects were larger after high-speed deformation at room temperature. Cu precipitation in the specimen deformed at the high-speed stopped for 10 h after annealing at 400 °C, while that in the specimen deformed at the low-speed continued for 100 h. Transmission electron microscopy (TEM) observations showed a heterogeneous distribution of dislocations in the case of low-speed deformation but a homogeneous distribution in the case of high-speed deformation. These results suggested that the sink efficiency for defects was higher in the specimen deformed at the high-speed.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Muon and positron interactions and applications · Microstructure and mechanical properties · Copper Interconnects and Reliability

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (15)

Show source-provided references
1. Kiritani · Phil. Mag. Lett. · 1999 · 79 · 79710.1080/095008399176616 ↗
2. Nagai · Phys. Rev. B · 2000 · 61 · 657410.1103/PhysRevB.61.6574 ↗
3. Nagai · Mater. Sci. Forum · 2001 · 363–365 · 9110.4028/www.scientific.net/MSF.363-365.91 ↗
4. Nagai · Phys. Rev. B · 2001 · 63 · 13411010.1103/PhysRevB.63.134110 ↗
5. Lynn · Phys. Rev. Lett. · 1977 · 38 · 24110.1103/PhysRevLett.38.241 ↗
6. Mijnarends · J. Phys.: Condens. Matter · 1998 · 10 · 10383
7. Matsui · J. Phys. Soc. Jpn. · 1992 · 61 · 18710.1143/JPSJ.61.187 ↗
8. Alatalo · Phys. Rev. B · 1995 · 51 · 417610.1103/PhysRevB.51.4176 ↗
9. Asoka-Kumar · Phys. Rev. Lett. · 1996 · 77 · 209710.1103/PhysRevLett.77.2097 ↗
10. Szpala · Phys. Rev. B · 1996 · 54 · 472210.1103/PhysRevB.54.4722 ↗
11. Onitsuka · Phys. Rev. B · 2002 · 65 · 01220410.1103/PhysRevB.65.012204 ↗
12. Komatsu · Radiat. Effects Defects Solids · 2002 · 157 · 7510.1080/10420150211418 ↗
13. Asoka-Kumar · J. Appl. Phys. · 1994 · 76 · 493510.1063/1.357207 ↗
14. H. Ohkubo, Z. Tang, Y. Nagai, M. Hasegawa, T. Tawara, M. Kiritani, Presentation at Symposium on High-Speed Plastic Deformation, Hiroshima Institute of Technology, Hiroshima, Japan, PII: S0921-5093(02)007050.
15. Yanagita · Mater. Trans. · 2002 · 43 · 166310.2320/matertrans.43.1663 ↗