Spherical indentation fatigue cracking
Source abstract
Abstract
Abstract The maximum principle stress in spherical indentation occurs at the periphery of the contact area. In a purely elastic material, the radial stress component σ r is tensile whilst the hoop component σ θ is compressive. The positions of σ r and σ θ are reversed in an elastic–plastic material under fully plastic indentation, where σ r is tensile and σ θ is compressive. It follows that the relative positions of σ r and σ θ vary as the load increases from yield towards the fully plastic deformation. This was demonstrated using a finite element (FE) model, where σ r , initially positive, was found to increase to a maximum and then decline with increasing load. In contrast, σ θ was negative at the yield load, but increased monotonically with increasing load to become the maximum principle stress component. The FE analysis is in line with experimental observations of fatigue induced by cyclic indentation. Ring cracks were generated with lower peak loads but fatigue fracture was dominated by radial cracks when cycling was done with higher peak loads. However, shallow ring cracks were observed to form under all loads. It is believed that the shallow ring cracks result from short-range asperity interactions, which are not modelled in the FE analysis.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Metal and Thin Film Mechanics · Advanced Surface Polishing Techniques · Advanced machining processes and optimization
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (14)
Show source-provided references
1. Johnson · 1985
2. Frank · Proc. R. Soc. London A · 1967 · 299 · 29110.1098/rspa.1967.0137 ↗
3. Zeng · Acta Metall. Mater. · 1992 · 40 · 259510.1016/0956-7151(92)90328-C ↗
4. Johnson · J. Mech. Phys. Solids · 1970 · 18 · 11510.1016/0022-5096(70)90029-3 ↗
5. Studman · J. Mater. Sci. · 1977 · 13 · 21510.1007/BF00566260 ↗
6. Kral · Trans ASME J. Appl. Mech. · 1993 · 60 · 82910.1115/1.2900991 ↗
7. Alfredsson · Fatigue Fract. Eng. Mater. Struct. · 1999 · 22 · 22510.1046/j.1460-2695.1999.00154.x ↗
8. Alfredsson · Eng. Fract. Mech. · 2000 · 65 · 8910.1016/S0013-7944(99)00108-3 ↗
9. Hardy · Int. J. Num. Meth. Eng. · 1971 · 3 · 45110.1002/nme.1620030402 ↗
10. Sinclair · Int. J. Solids Struct. · 1985 · 21 · 86510.1016/0020-7683(85)90039-3 ↗
11. Frost · 1974
12. Surface treatment, residual stress effects on the fatigue strength of carburized gears
13. Johnson · Proc. R. Soc. A · 1973 · 334 · 9510.1098/rspa.1973.0082 ↗
14. Alfredsson · Fatigue Fract. Eng. Mater. Struct. · 2000 · 23 · 22910.1046/j.1460-2695.2000.00269.x ↗