Microstructure and tribological property of selective laser melted Fe-Mn-Al-C alloy
Source abstract
Abstract
Abstract To investigate the microstructure and tribological property, Fe-16Mn-10Al-1.5C alloy was fabricated via selective laser melting technology at different laser scanning speeds for the first time in this study. The results show that the microstructure of Fe-Mn-Al-C alloy is composed equiaxed grains and columnar dendrites. And this alloy is mainly composed of γ-Fe. This alloy has high microhardness and low coefficient of friction (COF). The microhardness of the SLM part increases with the decrease of the laser scanning speeds. The sample prepared at the highest speed not only has the lowest COF, but also the lowest wear rate amongst these SLM parts and its wear mechanism is mainly abrasive wear and adhesive wear. The wear mechanism of the samples V0.4 and V0.28 is not only abrasive wear but also adhesive wear that produces grooves, which generates a large number of grooves during the wear test.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Additive Manufacturing Materials and Processes · High Entropy Alloys Studies · Metal Alloys Wear and Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (12)
Show source-provided references
1. Novel heat-resistant Al-Si-Ni-Fe alloy manufactured by selective laser melting10.1016/j.matlet.2018.11.033 ↗
2. Fatigue strength improvement of selective laser melted Ti6Al4V using ultrasonic surface mechanical attrition10.1080/21663831.2019.1609110 ↗
3. Microstructural evolution and mechanical property optimization under solution treatment of an ultra-low carbon Fe-Mn-Al duplex steel10.1016/j.msea.2018.09.097 ↗
4. Effect of aging on the microstructure and deformation behavior of austenite base lightweight Fe–28Mn–9Al–0.8 C steel10.1016/j.scriptamat.2010.07.036 ↗
5. Partitioning of C into κ-carbides by Si addition and its effect on the initial deformation mechanism of Fe-Mn-Al-C lightweight steels10.1016/j.jallcom.2018.10.104 ↗
6. Tensile deformation of a duplex Fe–20Mn–9Al–0.6 C steel having the reduced specific weight10.1016/j.msea.2011.03.045 ↗
7. Evolution of the microstructure and mechanical properties of an austenite–ferrite Fe–Mn–Al–C steel10.1016/j.msea.2015.07.043 ↗
8. Influence of Al content on the strain-hardening behavior of aged low density Fe–Mn–Al–C steels with high Al content10.1016/j.msea.2015.05.002 ↗
9. Fe–Al–Mn–C lightweight structural alloys: a review on the microstructures and mechanical properties10.1088/1468-6996/14/1/014205 ↗
10. Relationship between microstructures and tensile properties of an Fe-30Mn-8.5 Al-2.0 C alloy10.2320/matertrans.M2010013 ↗
11. Fretting wear mechanism for harmonic, non-harmonic and conventional 316L stainless steels10.1016/j.wear.2019.02.005 ↗
12. Enhanced hardness and wear property of S136 mould steel with nano-TiB2 composites fabricated by selective laser melting method10.1016/j.apsusc.2018.06.220 ↗