Microstructural features and tensile behaviors of a novel FeMnCoCr high entropy alloys
Source abstract
Abstract
Abstract C and Si-doped FeMnCoCr high entropy alloys (HEAs) with grain size of approximate 200 μm were prepared. Quasi-in-situ EBSD was used to characterize the microstructural evolution under different tensile strains. The tensile strength of the HEAs is about 670 MPa and the fracture elongation is 47%. The single-phase FCC structure was maintained during the entire tensile procedure, whereas the deformation mechanism was found to change from dislocation slip to twinning under higher strains. Moreover, it was observed that twins are inclined to form within grains with 〈1 1 1〉 texture.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: High Entropy Alloys Studies · High-Temperature Coating Behaviors · High Temperature Alloys and Creep
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (15)
Show source-provided references
1. A precipitation-hardened high-entropy alloy with outstanding tensile properties10.1016/j.actamat.2015.08.076 ↗
2. X.q Li, Development of strong and ductile metastable face-centered cubic single-phase high-entropy alloys10.1016/j.actamat.2019.09.050 ↗
3. Design of a twinning-induced plasticity high entropy alloy10.1016/j.actamat.2015.04.014 ↗
4. Twinning-Induced Plasticity (TWIP) Steels10.1016/j.actamat.2017.06.046 ↗
5. Interstitial atoms enable joint twinning and transformation induced plasticity in strong and ductile high-entropy alloys10.1038/srep40704 ↗
6. Ductile-brittle transition of carbon alloyed Fe40Mn40Co10Cr10 high entropy alloys10.1016/j.matlet.2018.10.144 ↗
7. Interstitial strengthening of a f.c.c. FeNiMnAlCr high entropy alloy10.1016/j.matlet.2016.05.122 ↗
8. Effect of solution treatment temperature upon the microstructure and mechanical properties of hot rolled Inconel 625 alloy10.1007/s10853-020-04375-2 ↗
9. The influence of manganese content on the stacking fault and austenite/e-martensite interfacial energies in Fe–Mn–(Al–Si) steels investigated by experiment and theory10.1016/j.actamat.2014.01.001 ↗
10. Joint contribution of transformation and twinning to the high strength ductility combination of a FeMnCoCr high entropy alloy at cryogenic temperatures10.1016/j.msea.2019.05.057 ↗
11. Stacking fault energy and deformation mechanisms in Fe-xMn-0.6C-yAl TWIP steel10.1016/j.msea.2016.08.106 ↗
12. Novel Co-rich high performance twinning-induced plasticity (TWIP) and transformation-induced plasticity (TRIP) high-entropy alloys10.1016/j.scriptamat.2019.02.018 ↗
13. Novel Co-rich high entropy alloys with superior tensile properties10.1080/21663831.2018.1553803 ↗
14. Suppression of twinning and phase transformation in an ultrafine grained 2 GPa strong metastable austenitic steel: experiment and simulation10.1016/j.actamat.2015.06.053 ↗
15. Softening behavior by excessive twinning and adiabatic heating at high strain rate in a Fe-20Mn-0.6C TWIP steel10.1016/j.actamat.2015.09.061 ↗