Boosting thermoelectric performance in Bi2Te3 crystals by Ge/Se co-doping and melt-growth synthesis
Source abstract
Abstract
This study investigates the structural and thermoelectric properties of intrinsic p-type Bi 2 Te 3 and (Bi 1- x Ge x ) 2 T e2.7 Se 0.3 single crystals, which were synthesized using a modified vertical Bridgman technique. X-ray diffraction analysis confirmed the formation of single-phase Bi 2 Te 3 and validated the optimized substitution of Ge and Se. The doped samples exhibited reduced thermal conductivity compared to the undoped counterpart, primarily due to enhanced phonon scattering mechanisms. Electrical transport measurements revealed that the enhancement in the thermoelectric figure of merit ( ZT ) is driven by reduced thermal conductivity, resulting from increased phonon scattering at grain boundaries and defects. In the sample with x = 0.04, a 2.3-fold reduction in thermal conductivity was observed, which led to approximately a 3-fold enhancement in the power factor (5394 μW/m·K 2 ) and a 3.9-fold increase in ZT value (0.67) compared to the pristine sample at 350 K. Consequently, a fourfold enhancement in the ZT value of ∼0.7 at 350 K was achieved for (Bi 0.94 Ge 0.06 ) 2 Te 2.7 Se 0.3 , due to a 5.6-fold reduction in electrical resistivity compared to Bi 2 Te 3 . These findings highlight the potential of Ge/Se co-doping and melt-growth synthesis in developing advanced thermoelectric materials. • Ge and Se co-doping in Bi2Te3, achieved through a modified vertical Bridgman method, successfully optimized structural and transport properties, resulting in homogeneous, single-phase materials. • The incorporation of Ge and Se significantly suppressed thermal conductivity in Bi2Te3, primarily due to enhanced phonon scattering from lattice imperfections, grain boundaries, and mass fluctuation effects. This reduction is critical for improving thermoelectric performance. • A nearly fourfold increase in the thermoelectric figure of merit (ZT) was observed in a sample with x=0.04 compared to undoped Bi2Te3, attributed to reduced thermal conductivity and a substantial increase in the power factor. This demonstrates the effective optimization of both thermal and electrical transport. • The (Bi0.94Ge0.06)2Te2.7Se0.3 composition achieved the highest ZT value of approximately 0.7 at 350 K, mainly due to a significant decrease in electrical resistivity. This research offers a scalable synthesis method and a viable path for enhancing low-temperature thermoelectric materials.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced Thermoelectric Materials and Devices · Topological Materials and Phenomena · Thermal properties of materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (45)
Show source-provided references
1. Power factor of bi2te3 and sb2te3 enhanced by high density and hardness10.55766/sujst-2023-05-e02873 ↗
2. Mechanical properties of Bi2Te3 topological insulator investigated by density functional theory and nanoindentation10.1016/j.scriptamat.2016.04.036 ↗
3. Dislocation, annealing and quenching effects on the microindentation hardness of Bi2Te3 and Bi2Te 2.9Se.1 single crystals10.1016/j.matchar.2003.06.001 ↗
4. The criteria for beneficial disorder in thermoelectric solid solutions10.1002/adfm.201201576 ↗
5. Rationally designing high-performance bulk thermoelectric materials
6. High-performance p-Type Bi2Te3-Based thermoelectric materials enabled via regulating Bi-Te ratio10.1021/acsami.3c18595 ↗
7. Ultra-fast fabrication of Bi2Te3 based thermoelectric materials by flash-sintering at room temperature combining with spark plasma sintering
8. Anisotropy analysis of thermoelectric properties of Bi2Te 2.9Se0.1 prepared by SPS method10.1063/1.4731579 ↗
9. Charge carriers modulation and thermoelectric performance of intrinsically p-type Bi2Te3 by Ge doping10.1016/j.jallcom.2018.02.310 ↗
10. Saberi · 2022
11. The p-n conduction type transition in Ge-incorporated Bi2Te3 thermoelectric materials10.1016/j.actamat.2016.09.043 ↗
12. Distinct role of Sn and Ge doping on thermoelectric properties in p-type (bi, Sb)2Te3-alloys10.1016/j.jssc.2020.121722 ↗
13. Ultralow thermal conductivity and high thermoelectric figure of merit in SnSe crystals10.1038/nature13184 ↗
14. Room-temperature exceptional plasticity in defective Bi 2 Te 3-based bulk thermoelectric crystals
15. Intrinsically low lattice thermal conductivity and anisotropic thermoelectric performance in In-doped GeSb2Te4 single crystals10.1002/adfm.202211281 ↗
16. Anionic regulation and valence band convergence boosting the thermoelectric performance of Se-alloyed GeSb2Te4 single crystal
17. In-doping induced resonant level and thermoelectric performance enhancement in n-type GeBi2Te4 single crystals with intrinsically low lattice thermal conductivity10.1016/j.cej.2023.143529 ↗
18. Thermoelectric properties of single-layered SnSe sheet10.1039/C5NR03813H ↗
19. Defect-engineered single crystal Bi2Te3 via Sb and Se doping for enhanced thermoelectric performance10.1007/s10853-025-11567-1 ↗
20. Crystalline perfection and mechanical investigations on vertical bridgman grown bismuth telluride (Bi2Te3) single crystals for thermoelectric applications10.1016/j.msea.2016.01.033 ↗
21. Bhat · 2015
22. H. Cao et al., “Topological insulator Bi 2 Te 3 films synthesized by metal organic chemical vapor deposition,” https://doi.org/10.1063/1.4760226.10.1063/1.4760226 ↗
23. An insight into experimental and theoretical thermoelectric property of antimony and tellurium-doped Bi2Se3 single crystals10.1007/s10854-025-14609-1 ↗
24. Exploiting the close-to-dirac point shift of the fermi level in the Sb2Te3/Bi2Te3 topological insulator heterostructure for spin-charge conversion10.1021/acsami.3c08830 ↗
25. Role of defects on carrier dynamics and transport mechanism in Bi2Te3 single crystals
26. Defect engineering via anionic disorders in n-type Bi1.8Sb0.2Te3 alloys: towards enhanced thermoelectric performance at low temperatures10.1088/1402-4896/adc63a ↗
27. Electrical transport properties of microwave-synthesized Bi 2Se3-xTex nanosheet10.1039/c3ce40296g ↗
28. H.-S. Kim, Z. M. Gibbs, Y. Tang, H. Wang, and G. J. Snyder, “Supplementary Information For: Characterization of Lorenz Number with Seebeck Coefficient Measurement.
29. Lattice strain enhances thermoelectric properties in Sb2Te3/Te heterostructure10.1002/aelm.201900735 ↗
30. Excellent dispersion effects of carbon nanodots on the thermoelectric properties of Bi2Te2.7Se0.3 with excessive Te
31. High-performance integrated chip-level thermoelectric device for power generation and microflow detection
32. High-performance bulk thermoelectrics with all-scale hierarchical architectures10.1038/nature11439 ↗
33. The p-n conduction type transition in Ge-incorporated Bi2Te3 thermoelectric materials10.1016/j.actamat.2016.09.043 ↗
34. High-performance flexible photodetectors based on GaTe nanosheets10.1039/C4NR07313D ↗
35. Gayner · 2016
36. Potential improvement in power factor of (Bi0.98Ge0.02)2Te2.7Se0.3 compound due to defect engineering10.1007/s10854-024-12673-7 ↗
37. Preparation and thermoelectric transport properties of high-performance p-type Bi2Te3 with layered nanostructure10.1063/1.2425007 ↗
38. Thermoelectric efficiency and compatibility10.1103/PhysRevLett.91.148301 ↗
39. Rationally designing high-performance bulk thermoelectric materials
40. High-performance bulk thermoelectrics with all-scale hierarchical architectures10.1038/nature11439 ↗
41. Fabrication of thermoelectric materials-thermal stability and repeatability of achieved efficiencies10.1039/C5TC02210J ↗
42. Rowe · 1995
43. Thermoelectric properties of co-doped (Bi0.98In0.02)2Te2.7Se0.3/reduced graphene oxide composites prepared by solid-state reaction
44. Witting · 2019
45. Improved electrical conductivity and power factor in Sn and Se co-doped melt-grown Bi2Te3 single crystal10.1007/s10854-021-06946-8 ↗