Controllable synthesis of metallo-alkoxide precursor-derived nickel aluminate spinels using TEA-gel process and morphology-dependent reducibility
Source abstract
Abstract
Abstract A study was made of the different preparation methods affecting the morphology and reducibility of the obtained NiAl 2 O 4 spinels. The NiAl 2 O 4 with various morphologies has been fabricated through the dependent control of TEA (triethanolamine) -gel parameters. Compared to the NiAl 2 O 4 prepared from a direct calcination of spinel precursors, the superb structural characteristics of the NiAl 2 O 4 including large surface area and well-defined interconnected nanoparticles were observed via the TEA-gel route. The NiAl 2 O 4 prepared by TEA-gel method yields the highest degree of surface reduction with the largest amount of metallic nickel phase found in the spinels. This spinel also had the lowest initial temperature of reduction. The results indicate that the NiAl 2 O 4 prepared by the TEA−gel technique using our new spinel alkoxide precursor has a promising prospect in the preparation of nickel catalyst supports where there is a need to avoid the traditional multiple procedures that are time-, solvent-as well as high energy-consuming.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Pigment Synthesis and Properties · Catalytic Processes in Materials Science · Catalysis and Oxidation Reactions
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (43)
Show source-provided references
1. Chemistry and properties of nanocrystals of different shapes10.1021/cr030063a ↗
2. Self-assembly of mesoscale objects into ordered two-dimensional arrays10.1126/science.276.5310.233 ↗
3. Versatility of one-pot, single-step synthetic approach for spherical porous (metal) oxide nanoparticles using supercritical alcohols10.1016/j.supflu.2013.03.023 ↗
4. Salt gel synthesis of porous transition metal oxides
5. Highly dense, Transparent-Al2O3 ceramics from ultrafine nanoparticles via a standard SPS sintering10.1111/jace.12255 ↗
6. Rapid sonochemical synthesis of irregular nanolaminar-like Bi2WO6 as efficient visible-light-active photocatalysts10.1016/j.ultsonch.2012.07.019 ↗
7. Chemical inhomogeneities in yttrium barium copper oxide produced by conventional sintering10.1016/0025-5408(89)90003-2 ↗
8. Electrochemical synthesis of barium cuprate
9. Mechanochemical synthesis of fluor- and chloroapatites izvestiya sibirskogo otdeleniya akademii nauk SSSR
10. Self-propagating high-temperature synthesis of refractory inorganic compounds, metalloterm
11. Chemistry of sol-gel synthesis of aluminum oxides with in situ water formation: control of the morphology and texture10.1021/cm00048a029 ↗
12. Nanoscale control of the morphology of lithium manganate and silica composites using self-organized Sol−Gel media10.1021/cm9705698 ↗
13. Synthesis and characterization of Sol−Gel hydrotalcites. Structure and texture10.1021/la940703s ↗
14. DTA-TGA and FTIR spectroscopies of sol-gel hydrotalcites: aluminum source effect on physicochemical properties10.1016/S0167-577X(96)00296-0 ↗
15. Synthesis, characterization and properties of nanostructure zinc oxide/cobalt oxide composite film coated on glass by sol-gel spin-coating process for textile dye removal in aqueous solution10.1016/j.jiec.2013.09.060 ↗
16. Preparation of super-microporous WO3-SiO2 olefin metathesis catalysts by the aerosol-assisted sol-gel process10.1016/j.micromeso.2015.04.020 ↗
17. Facile synthesis, characterization and magnetic property of CuFe12O19 nanostructures via a sol-gel auto-combustion process10.1016/j.jmmm.2015.10.049 ↗
18. Cationic and anionic vacancies in the crystalline phases of Sol−Gel Magnesia−Alumina catalysts10.1021/cm9805471 ↗
19. Mg/Al mixed oxides prepared by coprecipitation and sol–gel routes: a comparison of their physico-chemical features and performances in m-cresol methylation10.1016/j.micromeso.2003.09.010 ↗
20. Effects of thermal treatment on the micro-structures of co-precipitated and sol–gel synthesized (Mg–Al) hydrotalcites10.1016/j.micromeso.2006.02.007 ↗
21. Gamma-Al2-xMxO3 +/- y (M = Ti4+ through Ga3+): potential pseudo-3D mesoporous materials with tunable acidity and electronic structure10.1039/c2jm31184d ↗
22. A rationally designed CuFe2O4-mesoporous Al2O3 composite towards stable performance of high temperature water-gas shift reaction10.1039/c3cc43699c ↗
23. Carbon deposition and catalyst stability over La2NiO4/gamma-Al2O3 during CO2 reforming of methane to syngas10.1016/S0926-860X(02)00591-4 ↗
24. Stability improvements of Ni/alpha-Al2O3 catalysts to obtain hydrogen from methane reforming10.1016/j.ijhydene.2008.12.057 ↗
25. Morphology, microstructure, and magnetic properties of ordered large-pore mesoporous cadmium ferrite thin film spin glasses10.1021/ic302283q ↗
26. Evidence for the participation of surface nickel aluminate sites in the steam reforming of methane over nickel/alumina catalysts10.1016/0021-9517(78)90142-2 ↗
27. Synthesis of high surface area CoAl2O4 and NiAl2O4 spinels by an alkoxide route10.1163/156856799X00293 ↗
28. Nickel-aluminium complex: a simple and effective precursor for nickel aluminate (NiAl2O4) spinel
29. Preparation of nickel aluminate spinel by solid state reaction
30. Development of a novel chemical-looping Combustion: synthesis of a solid looping material of NiO/NiAl2O410.1021/ie9803265 ↗
31. Inverse NiAl2O4 on LaAlO3-Al2O3: unique catalytic structure for stable CO2 reforming of methane10.1021/jp401855x ↗
32. Control of mesoporous structure of aerogels derived from cresol-formaldehyde10.1006/jcis.2002.8573 ↗
33. Preparation and properties of resorcinol-formaldehyde organic and carbon gels10.1002/adma.200390020 ↗
34. NiAl2O4 catalysts prepared by combustion reaction using glycine as fuel10.1016/j.materresbull.2011.05.011 ↗
35. Characterization of Mg1-xNixAl2O4 solid solutions prepared by combustion synthesis10.1016/j.jeurceramsoc.2010.12.011 ↗
36. Reporting physisorption data for gas/solid systems with special reference to the determination of surface area and porosity10.1351/pac198557040603 ↗
37. CH(4)-CO(2) reforming over Ni/Al(2)O(3) aerogel catalysts in a fluidized bed reactor10.1016/j.powtec.2007.05.024 ↗
38. Temperature-programmed-reduction studies of nickel oxide/alumina catalysts: effects of the preparation method10.1016/0040-6031(94)02177-P ↗
39. The influence of nickel loading on reducibility of NiO/Al2O3 catalysts synthesized by sol-gel method10.3329/cerb.v14i2.5052 ↗
40. Comparative study of the dry reforming of methane on fluidised aerogel and xerogel Ni/Al2O3 catalysts10.1007/s13203-013-0035-9 ↗
41. A comparison of NiMo/Al2O3 catalysts prepared by impregnation and coprecipitation methods for hydrodesulfurization of dibenzothiophene10.1021/jp068482+ ↗
42. A novel catalyst with plate-type anodic alumina supports, Ni/NiAl2O4/g-Al2O3/alloy, for steam reforming of methane10.1016/j.apcata.2008.06.007 ↗
43. Synthesis and characterization of several Ni/NiAl2O4 catalysts active for the 1,2,4-trichlorobenzene hydrodechlorination10.1016/S0926-3373(99)00133-2 ↗