journal article·2022-08Open access

Probing water uptake gradient in an epoxy matrix via scanning electrochemical microscopy

A. Renaud, F. Hache, Y. Elkebir, J. Valette, S. Mallarino, D. Trinh, S. Touzain

Abstract

Scanning electrochemical microscopy (SECM) is used to detect and observe the presence of water inside polymeric film at the microscopic scale around 200–500 μm. The principle is based on the use of SECM performed with a room temperature ionic liquid (RTIL) and K4Fe(CN)6 as redox sensor. The particular electrochemical behaviors obtained in such medium have been investigated by performing cyclic voltammetry and approach curves in negative feedback mode. Then, the cross-section of epoxy resin films has been repeatedly scanned using the SECM probe over several days of immersion in the RTIL. As the presence of water impacts the electrolyte viscosity, the electrochemical signal was sensitive to the amount of water around the microelectrode. The sensitivity of this technique to the presence of water released from the materials at the microscopic scale was demonstrated by comparing electrochemical signals obtained on dry and saturated specimens. Such results appeared to be very promising for the development of new methods to locally detect the presence of water in thick polymeric materials and to measure humidity gradient within the material thickness.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Electrochemical Analysis and Applications · Conducting polymers and applications · Analytical Chemistry and Sensors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (57)

Show source-provided references
1. Study of microbiologically induced corrosion of 5052 aluminum alloy by sulfate-reducing bacteria in seawater10.1016/j.matchemphys.2019.122296 ↗
2. A study of the use of polyaspartic acid derivative composite for the corrosion inhibition of carbon steel in a seawater environment10.1016/j.molliq.2019.111634 ↗
3. An experimental study on stress corrosion behavior of A131/A and A131/AH32 low carbon steels in simulated seawater10.1016/j.oceaneng.2019.106204 ↗
4. Anisotropic fluid diffusion in carbon fiber reinforced composite rods : experimental, analytical and numerical study10.1016/j.marstruc.2018.01.003 ↗
5. Influence of delaminations on fluid diffusion in multidirectional composite laminates – theory and experiments
6. Degradation in fatigue behavior of carbon fiber-vinyl ester based composites due to sea environment10.1016/j.compositesb.2014.01.030 ↗
7. Seawater durability of glass- and carbon-polymer composites10.1016/j.compscitech.2003.10.019 ↗
8. Seawater ageing of glass fiber reinforced epoxy nanocomposites based on silylated clays10.1016/j.polymdegradstab.2017.11.017 ↗
9. Marine ageing behaviour of new environmentally friendly composites10.1007/978-3-319-65145-3_12 ↗
10. P. Davies, Y.D.S. Rajapakse Editors, Durability of Composites in a Marine Environment, n.d. https://doi.org/10.1007/978-94-007-7417-9.10.1007/978-94-007-7417-9 ↗
11. Water absorption and blistering of glass fibre-reinforced polymer marine laminates with nanoparticle-modified coatings10.1177/0021998313503877 ↗
12. Impact of sea-water on the quasi static and fatigue flexural properties of GFRP10.1016/j.compstruct.2012.10.021 ↗
13. Fatigue behaviour of glass fibre reinforced composites for ocean energy conversion systems10.1007/s10443-012-9260-0 ↗
14. Characterization of sea water ageing effects on mechanical properties of carbon/epoxy composites for tidal turbine blades10.1016/j.compositesa.2015.08.035 ↗
15. Water uptake in free films and coatings using the Brasher and Kingsbury equation: a possible explanation of the different values obtained by electrochemical Impedance spectroscopy and gravimetry10.1016/j.electacta.2017.02.051 ↗
16. Study of the interfacial degradation of a glass-epoxy composite during hygrothermal ageing using water diffusion measurements and dynamic mechanical thermal analysis10.1016/0032-3861(94)90730-7 ↗
17. Ueber diffusion10.1002/andp.18551700105 ↗
18. P. Davies, Y.D.S. Rajapakse Editors, Durability of Composites in a Marine Environment, n.d. https://doi.org/10.1007/978-94-007-7417-9.10.1007/978-94-007-7417-9 ↗
19. Free/bound water absorption in an epoxy adhesive10.1016/j.polymer.2005.09.008 ↗
20. Langmuir-type model for anomalous moisture diffusion in composite resins10.1177/002199837801200201 ↗
21. A fully coupled diffusion-reaction scheme for moisture sorption e desorption in an anhydride-cured epoxy resin10.1016/j.polymer.2012.09.037 ↗
22. Assessment of approximate models to evaluate transient and cyclical hygrothermoelastic stress in composite plates10.1016/j.ijsolstr.2006.05.014 ↗
23. A novel protocol for rapid identification of anisotropic diffusion properties of polymer matrix composite materials with complex texture10.1016/j.compstruct.2018.05.142 ↗
24. Combined experimental/numerical investigation of directional moisture diffusion in glass/epoxy composites10.1016/j.compscitech.2017.08.002 ↗
25. Marine ageing behaviour of new environmentally friendly composites10.1007/978-3-319-65145-3_12 ↗
26. The spectroscopic determination of aqueous vapor10.1086/141923 ↗
27. Korotcenkov · 2020 · vol. 3 · 1
28. Near-infrared spectroscopic method for monitoring water content in epoxy resins and fiber-reinforced composites10.3390/ma11040586 ↗
29. Va\vsková · 2011
30. Towards self-diagnosis composites: detection of moisture diffusion through epoxy by embedded evanescent wave optical fibre sensors10.1016/j.polymertesting.2018.09.019 ↗
31. In situ monitoring of organic coating swelling by dynamic mechanical analysis and scanning electrochemical microscopy10.1016/j.porgcoat.2016.01.026 ↗
32. Effect of physical ageing onto the water uptake in epoxy coatings10.1016/j.electacta.2020.135766 ↗
33. Influence of internal stresses on the physicochemical and mechanical properties evolution of pigmented epoxy systems during hygrothermal ageing10.1016/j.surfcoat.2017.10.013 ↗
34. Progress in scanning electrochemical microscopy by coupling with electrochemical impedance and quartz crystal microbalance10.1002/cphc.200900506 ↗
35. Alternating-current measurements in scanning electrochemical microscopy, part 1: principle and theory
36. Evaluation of a Ag/Ag 2 S reference electrode with long-term stability for electrochemistry in ionic liquids10.1016/j.elecom.2018.02.005 ↗
37. Electron transfer controlled by solvent and counter-anion dynamics in electrochemistry of viologen-type ionic liquid10.1016/j.electacta.2019.134559 ↗
38. Electrochemistry of the tris (2,2‘-bipyridine) complex of iron (II) in ionic liquids and aprotic molecular solvents10.1016/j.electacta.2016.10.126 ↗
39. Preparation and crystal structure of tetraoctylphosphonium tetrakis (pentafluorophenyl) borate ionic liquid for electrochemistry at its interface with water10.1016/j.cattod.2017.05.030 ↗
40. Use of ionic liquids in SECM experiments to distinguish effects of temperature and water in organic coating swelling10.1016/j.porgcoat.2019.105438 ↗
41. Electrochemistry in deep eutectic solvents10.1021/jp075794j ↗
42. Ultramicroelectrode voltammetry and scanning electrochemical microscopy in room-temperature ionic liquid electrolytes10.1039/b822846a ↗
43. An inert ionic liquid-based system for ascertaining electrolyte diffusivity in protective coatings10.5006/1362 ↗
44. Determination of water in room temperature ionic liquids by cathodic stripping voltammetry at a gold electrode10.1021/ac2031173 ↗
45. Electrochemical quantification of hygroscopicity of ionic liquids with solution-dissolved potassium ferricyanide as the redox probe10.1002/elan.201100533 ↗
46. Nonadditivity of faradaic currents and modification of capacitance currents in the voltammetry of mixtures of ferrocene and the cobaltocenium cation in protic and aprotic ionic liquids10.1021/ja8092295 ↗
47. Electrochemical quantification of hygroscopicity of ionic liquids with solution-dissolved potassium ferricyanide as the redox probe10.1002/elan.201100533 ↗
48. Efficient detection of localized corrosion processes on stainless steel by means of scanning electrochemical microscopy (SECM) using a multi- electrode approach10.1016/j.elecom.2019.02.019 ↗
49. Direct detection of label-free blood fingermarks by SECM imaging10.1016/j.elecom.2019.04.003 ↗
50. SECM investigation of corrosion inhibition by tungstate- and vanadate-doped polypyrrole/aluminum flake composite coatings on AA2024-T3 We dedicate this manuscript to our colleague, mentor, and friend, Professor Gordon P. Bierwagen10.1016/j.porgcoat.2014.05.019 ↗
51. SECM study of the pH distribution over Cu samples treated with 2-mercaptobenzothiazole in NaCl solution10.1016/j.elecom.2017.04.005 ↗
52. Mass transport and heterogeneous electron transfer of a ferrocene derivative in a room-temperature ionic liquid10.1016/j.jelechem.2009.04.001 ↗
53. Electrochemistry in deep eutectic solvents10.1021/jp075794j ↗
54. Effect of physical ageing onto the water uptake in epoxy coatings10.1016/j.electacta.2020.135766 ↗
55. Electrochemistry in room temperature ionic liquids : a review and some possible applications10.1524/zpch.2006.220.10.1247 ↗
56. Effect of viscosity on steady-state voltammetry and scanning electrochemical microscopy in room temperature ionic liquids10.1021/jp912087n ↗
57. Mass transport and heterogeneous electron transfer of a ferrocene derivative in a room-temperature ionic liquid10.1016/j.jelechem.2009.04.001 ↗