Construction and Properties of High-Toughness Soft–Soft Interfaces Based on the Adhesion of Natural Polyphenols

Artificial joint replacement is the most effective way to treat osteoarthritis. However, these artificial joints are too stiff with high interfacial contact stress and poor surface lubrication, resulting in stress shielding and severe wear and tear lead to an extremely high failure rate. At present, hydrogels are considered the most promising substitute for artificial joint prostheses owing to their good biocompatibility, adjustable mechanical properties, and excellent flexibility. Nevertheless, a traditional single-layer hydrogel has poor bearing capacity and lubrication, which are far from the properties of natural articular cartilage. The high strength and low friction properties of natural articular cartilage are based on its own multilayer fibrous structure. Therefore, by simulating the multilayer structure of natural cartilage, a bilayer bionic cartilage hydrogel was prepared; that is, the upper hydrogel realized excellent lubrication and the lower hydrogel realized high load-bearing capacity. However, the interface binding of bilayer hydrogels is a challenge at present. Therefore, the interfacial adhesion of the bilayer hydrogel is improved by adding tannic acid (TA) based on the adhesion of the natural polyphenol structure. The average interfacial toughness reaches 3650 J/m 2, and the average interfacial shear force reaches 800 kPa. In the preparation of the bilayer hydrogel, taking advantage of the coordination reaction between TA and metal cations, Fe 3+ is further added to endow the bilayer hydrogel with excellent mechanical properties and good sliding friction performance. Therefore, this work opens up a new way to construct cartilage-like materials with high toughness and a soft–soft interface.