article·2016-02-01Open access

Effect of MAG welding on microstructure and mechanical properties of dual phase steel

S. ULU, M. CAKMAKKAYA, Şükrü Talaş

Abstract

In this study, the effect of metal active gas (MAG) welding has been evaluated on the microstructural and mechanical properties of dual phase steel. Low carbon dual phase steels containing varying volume fraction of martensite was produced with coarse and fine microstructure. Specimens were joined by MAG welding method and tensile tests and microstructural analysis were performed on these specimens. Initial microstructure of steel plates appears to be a factor in determining the microstructure of heat affected zone (HAZ). Average grain size in MAG weld metal deposited on fine grained dual phase steels produced was in the range of 7.7 to 8.9 micron. Columnar grains with comparatively large average grain size were also observed in weld metals. Yield and maximum tensile strengths are relatively lower than those of non welded steels. Tensile strengths of weld metals (WM) deposited on initially coarse grained dual phase steels yielded better results than those with initially fine grained dual phase steels. K e y w o r d s : dual phase (DP) steel, metal active gas (MAG) welding, microstructure, mechanical properties
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Microstructure and Mechanical Properties of Steels · Welding Techniques and Residual Stresses · Advanced Welding Techniques Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.